Hi all does any one if you can take the head off a 08 rev 3 250 whilst the engine is still in the frame. Thanks

Oddly I did just this on my 08 and turned a bit out of head on my lathe so was easier to kick over. Worked well.

Lol yeah had to drop the swing arm bout out and leave the lower bolt in so it came towards. Didn't have a lath just a mirror and 400 wet n dry and figure of 8 trees up the head. It was a weird warp as it was domed so the edges were high. Back together now but snaped the front lower ending mount. I do t think the 50nm torque is correct