Morning Chappo, scouring the forums I picked up that you had repacked Bultaco exhausts by opening them up etc. I think I need to do the same as mine are untouched. Before a plough in with the Dremel, do you have any photos or drawings as guidance? Would I be right in saying it is the front box, and the upright section of the rear as the square end section has just baffles and doesn't contain wadding? Not having welding facility, I was thinking of riveting a plate over the holes?
I have 2 of these available. They are made from T6 6061 aluminium. They were originally made to fit a 199a but I am told that most of the Bultaco yokes are similar, so it may well fit others as well. They are available as either, just the yoke, at
£65. Or with a choice of standard or fatbar clamps with 25mm or 45mm rise for an extra £25. Alternatively, any modern bar clamp with 40mm between bolts will fit. Postage within England is £5. Postage elsewhere is at cost.
Satisfaction guaranteed. If you are not completely happy with your purchase, I am happy to refund you. To order, please message me or call on 07590662450
Hi Robert, I live in Morecambe and our local club is Lancs County MCC,which run events around the Lancaster area, the next event is New Years Day at Arkholme near Carnforth. The nearest official practice area is at Back Cowm Leisure, Rossendale, theres a link from the Trials Central site.........hope this helps and good luck. Dave.
Hi Robert, I live in Morecambe and our local club is Lancs County MCC,which run events around the Lancaster area, the next event is New Years Day at Arkholme near Carnforth. The nearest official practice area is at Back Cowm Leisure, Rossendale, theres a link from the Trials Central site.........hope this helps and good luck. Dave.