nakednutt

Is there anywhere online with a manual for a 2007 250 sherco? I need to change fork seals and wouldn't mind a look at a manual before I do it. Thanks

has anyone had any trouble with the fan couling rubbing through the solder on the radiator? if so how do you stop it from happening

i checked it earlier and its definately drawing air in from somewhere. its fine until it gets warm then air bubbles start appearing in the cup. any ideas?

cheers copemech. i'll try that

i changed the seals today but it's still the same. it only pumps it out when the engine is warm. any ideas?

what would cause drops of oil to come out of a 2007 250 sherco gearbox breather apart from too much oil in it. i noticed the fill plug isnt seating great. i plan on ordering one from splatshop tomorrow.

anyone any experience with forma boulders? i fancy trying these http://www.ebay.co.uk/itm/FORMA-2011-BOULDER-TRIALS-QUAD-OFFROAD-BOOTS-BROWN-11-/360435043246?pt=UK_Motorcycle_Boots&hash=item53eb9a4bae

i changed the plates and took the grooves off the basket and its now spot on once warm. thanks again

when you cleaned the plates with a dremel did you take it right back to the steel? or just cleaned the groove?

will let you know how i get on. cheers

anyone any experience with the apico plates from bvm?

Thats the answer i was looking for. Cheers

i cleaned my clutch and it was rideable but still dragging for 3-4 outings but its back to dragging bad again.

thanks clay. i'm looking to change the full clutch.

anyone recomend a clutch?