| |
-
yep its normal my 125 09 does it and so does my dad 250 nothing to worry about
-
thanks guys,just checking
-
high changing a tube yesterday and i felt the disk rotor on the front wheel felt loose,checked my dads bike it was the same are they meant to be like it?
thanks sam
-
i am no expert but it sounds like there is no fuel getting into the engine,blocked fuel pipe or fuel filter maybe?
-
i was having a play with the mapping switch on my 09 125 it doesnt seem to do much even at high revs.is this normal or is there very small difference between the two settings?
-
normally we only tow with one are two bikes on our 3 bike trailer but next week we are taking a mate to a trial,and the 3 bikes will not fit on the trailer together without the bars interferring with each other,what can i do to fix this problem?
thanks,sam
-
lol.but adding racing stripes will give you an extra 4bhp.
-
montesa never riden one they just look very cool
-
Would it be possible to spray paint brake resvoir caps?if so what would you do?just apply the spray paint?
thanks,sam
-
so just fairy liquid and warm water leave it to soak for 5 or 10 mins ?
then leave it to dry overnight and spray filter oil on it in the morning?
-
how do you clean it?
should i clean it when i can barely see the colour of it?
-
can i oil my air filter even when its dirty?well not dirty just a bit dusty.
when should i remove and clean the air filter?
thanks,sam
-
o right sorry when you say a diode in series do you mean put a diode after the last led so when the curent alternates you only get current flowing for half the time,if you get what i mean
sorry to keep asking you about this stuff,thanks sam
-
i think that it is AC because of this diagram,http://www.trialspartsusa.com/diagrams/KokusanDigital2005Pro.jpg.(i would think that this 05-07 diagram is simmilar to the 09 wiring)
so would i have to make a rectifier with 4 diodes?
thanks,sam wheelhouse
-
thanks,i havnt looked at it yet but i will,so about a 400 ish ohm resistor and 5 or 6 leds
this wont damage the bike will it?
is the suply AC or DC?
-
hi,i have a gg 09 125 i have just bought a number board for it and have had to remove the front light,i am doing gcse electronics was wondering if i could make a row of leds to go either over or under the number board.i understand the suply to the front light is 12v so how many leds would i need to :not explode the leds, not damage the bike but make the leds turn on if i conected them in series.
sorry this i a bit of a nerdy question.Sam
-
hi,i have a 2009 125 when the bike idles in neutral there is a knocking noise from the engine but when i pull the clutch in it stops.does yours do this?any ideas?
thanks, sam
-
on the make front you will always get different answers mainly being :gasgas beta or sherco.a good engine size for a novice is probally a 200 but if you have been doing green laning then a 250 will probally be fine.
-
no,that makes perfect sence at the higher reves the engine gives more power,had a quick play with it today,thanks.
-
what does the different mapping settings acctualy do?
-
i have got a 2009 125 gasgas,will mine have this mapping switch?on my handlebars there are two switches one controls the lights and the other one appears to do nothing could this be the mapping switch?
-
i am using putoline gp10 synthetic sae 75w gearbox oil,is this suitable?
-
It is more the pouring that is the problem
-
i have read somewhere not to use synthetic gearbox oil,i am currently using synthetic is this doing any damage /do i need to change.
thanks,sam
-
I have got two green plastic 5 litre petrol cans.they both leak fuel everywhere and i need a good quality one who does one/where can i get one/any other solutions?
any help appreciated
thanks,sam
|
|
