Jump to content

rob270beta

Members
 View Profile  See their activity

  • Posts

    13

  • Joined

  • Last visited

 Content Type 

Everything posted by rob270beta
 
 
  1. rob270beta
    Hi Guys I've just bought a tiger cub in need of restoration and would be grateful for any info on the best places to get spares and trials parts . I live in Bristol so any outlets in the South West will be handy to know. Thanks Rob
  2. rob270beta
    Thanks for the replys
  3. rob270beta
    Hi , these engines need to be ran on a rich idle setting . Ive now set my needle on bottom clip postion (needle raised fully) . Mixture screw is about 3 turns from fully closed as its a fuel screw not air screw . Best way to set is start about 2 turns out and then turn out 1/4 turn at a time if idle rises turn idle scew to lower tickover keep doing this until no change in idle speed . Good Luck Rob
  4. rob270beta
    Hi all , Which way do the mesh oil filters fit in the 4t engines . I have the manual but it doesnt show or state whether the small or large hole should be facing in or out . Ive spoken to beta uk and they arent too sure . Thanks Rob
  5. rob270beta
    Thanks for the replys . All ok now , had over filled it with oil !
  6. rob270beta

    beta 4t oil pump

    rob270beta posted a topic in Beta

    Hi guys, just changed oil on my rev 4t, cant remember if oil should dissappear from sight glass when running . Is there anyway to check that oil is being pumped around any advice would be much appreciated . Thanks Rob
  7. rob270beta
    Thanks Portman , ive just seen the bolt on the manual cover .
  8. rob270beta
    Hi guys , think i may have head gasket gone , any tips on replacing would be very much appreciated. I do have a download of the workshop manual which is quite good as a start . It mentions about a tdc locking bolt but im not sure exactly where it is !.Do i need to remove water pump shaft or can i leave it in place and just drop chain off camshaft sprocket . Thanks Rob
  9. rob270beta
    Hi . Thanks for the reply , all sorted now .
  10. rob270beta
    JUST TAKEN THE TWO INTERNAL OIL FILTERS OUT TO CLEAN ON AN 08 250 REV4T , CANT REMEMBER WHICH WAY ROUND THEY FIT INTO ENGINE AS ONE END HAS A BIGGER HOLE THAN THE OTHER . WOULD APPRECIATE ANY ADVICE ,THANKS ROB
  11. rob270beta
    Thanks for replying so fast , i'll blank it off properly now i know its supposed to be like that . Thanks Rob
  12. rob270beta
    Hi guys , just picked up an 08 rev4 can anyone tell me why this pipe may have been blocked off and where is it supposed to be attached to. Is it a mod that is done to the bike as it seems to run ok. Thanks Rob
  13. rob270beta
    HI GUYS , IM ABOUT TO REFIL MY 2010 GASGAS MARZOCCHI FORKS , ROUGHLY HOW MUCH OIL DO THEY TAKE TO ACHEIVE THE 160MM AIR GAP . IVE PUT 80MM OF OIL IN THE BOTTOM OF THE CARTRIDGE BUT I WOULD LIKE TO FIND OUT HOW MUCH EXTRA GOES IN AS WHEN I STRIPPED THEM I ONLY HAD ABOUT 100MM DRAIN OUT OF EACH LEG , WHICH DOESNT SEEM ENOUGH ! THANKS ROB
 
×
  • Create New...