Are all wheel bearing the same in a rear wheel from a KTM (125-525cc) I've bought a wheel off flee bay and the bearing need doing but I'm unsure of the age and cc the wheel came from. Regards
Hi check out www.saundersextremesports.co.uk for all the trick bits for the evo they have got loads of stuff on there including the rad cap cover!
Rad cover is held on with cable ties seems a little 'heath robinson' to me, just like the CDI cover, not much thought has been put into the product from a practical point of view, and are they really needed, or are they just there for us to spend extra money on. Sorry to hijack your thread
I also know the guys from BVM, the two young lads in the parts dept are very good riders so the 08 bike your on about would have seen a lot of full throttle action perhapse this is the reason for the rebuild, also remember if the engine had seen a lot of action then the other components would have as well and not been replaced (forks, rear shock etc). Have a look at the coating on the forks if this is starting to wear then i would be walking away rather quickly
I've got a Beta Rev3 06, and have replaced the rubber shock protector a few times in it's life do Gasgas and sherco's use the same type of rubber guard? I pay about
Can someone please help me here before i go out of my mind.......I've taken the clutch plates out, cleaned them and roughed the surface and have replaced them, checked the springs and cups and replaced them aswell, can someone please tell me the steps to setting the clutch, i've had a go and got no-where. Many Thanks
Okay just got back from the MOT station today, and it failed on 'noise' only, now that's not bad for a 1973, people that know about Bultaco's know they have a 3 piece system, well.... i have the last section missing so i expected it to be loud, is there anything that i can do to quieten the old girl down without having to buy the final section, can i pack the second section with anything just to get it through the MOT?
Hi chaps my 270 (06) has started 'hunting' (not a steady tick over) after about 1/2 hours riding, Ive not changed fuel or mix %, air filter is clean, can anyone help. Many Thanks
On a Amal Carb if you start the bike and it run for about 1min on tick over and it then stops, what would be the problem? If i tickle it again it will start, it's as if the fuel reservoir is emptying, is the float jamming or is there a hole blocked somewhere
That would be great if you could do that, could you measure the length of the rod aswell, also how can you tell by looking that the clutch needs replacing, if i'm gong to be around that area i'd like to check
5.5mm is about 7/32" i tried this size (sorry i did say 5/32) if you say it should be 7/32 then there is a ball already stuck up the tube, strange as there seems to be a lot of free play before the vertical arm that pushes the rod actually come into contact with the ball.
As you all have guessed i'm new to T/shocks the 250 T is my first, it was mis-treated by a Yorksire man in it's youth, I've got hold of her now and i'm breathing some life back into her.
Ktm Wheel Bearings
in Enduro
Posted
Are all wheel bearing the same in a rear wheel from a KTM (125-525cc) I've bought a wheel off flee bay and the bearing need doing but I'm unsure of the age and cc the wheel came from. Regards