Jump to content

Sign in to follow this  
clay

315 Swing Arm Movement

Recommended Posts

When my bikes on the stand, should there be any vertical movement with the swing arm, as mine has about 3/4" play. ive replaced the dog bone bearings, and it does look like the plays coming from the bottom of the shock,,, (Thanks in advance)

Share this post


Link to post
Share on other sites
 

There are bearings in the shock - top and bottom. There should be minimal if no play vertically.

Share this post


Link to post
Share on other sites
 

The bottom 'eye-ball' bearing gets a bit sloppy with age ,unfortunately it seems to be an unusual size and I couldn't source one cheaply from the mainstream bearing stockists :wall: .Good luck,I think you're in the dealers' hands.

Share this post


Link to post
Share on other sites
 

It is rare for the bottom "heim joint" bearing to fail. Check the bolts or the holes on the triangle plates to see if the have ovaled out. Did you replace the bearing on the swing arm where the linkage connects?

Share this post


Link to post
Share on other sites
 

Replaced the underside bearings of the swing arm, at same time as i did the dog bones,,

will check for wear on the bolts / plates at weak end.

but think ham2 right, (more over time needed)

Share this post


Link to post
Share on other sites
 

Most likely to be the plates. Just a smidge of play there will relate to loads at t'other end of the swingarm.

If it is a shock bearing, check the price and give me a shout - pretty sure I have one or two here I'm never going to use, I'll do you a deal.

Share this post


Link to post
Share on other sites
 

Most likely to be the plates. Just a smidge of play there will relate to loads at t'other end of the swingarm.

If it is a shock bearing, check the price and give me a shout - pretty sure I have one or two here I'm never going to use, I'll do you a deal.

Hi bud, ive sent you a pm

Share this post


Link to post
Share on other sites
 

Got round to checking the lower suspension, And your right lads,

The plates are slightly worn, so ive ordered the uprated plates, (not sure if there worth the extra cost)

Thanks again for the input

Share this post


Link to post
Share on other sites
 
 
 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...