furse Posted March 24, 2012 Report Share Posted March 24, 2012 Alloy swing arm finally fitted to 200pro, just a few mods I still want to do before the strip down to be powder coated, when it will also recieve a lot of polishing or anodizing. 1 Quote Link to comment Share on other sites More sharing options...
axulsuv Posted March 24, 2012 Report Share Posted March 24, 2012 What did the swing arm start life as ? Looks Good Glenn Quote Link to comment Share on other sites More sharing options...
furse Posted March 24, 2012 Author Report Share Posted March 24, 2012 It came from a Rev3 Quote Link to comment Share on other sites More sharing options...
axulsuv Posted March 25, 2012 Report Share Posted March 25, 2012 How much work was need to get the pivot bolt to work , with the motor mount and new arm ? Quote Link to comment Share on other sites More sharing options...
zerorev3rev4 Posted March 25, 2012 Report Share Posted March 25, 2012 It came from a Rev3 are you sure it came from rev3 as they have a mounting point on left side for the shock and they finish differnt towards the wheel end ,it looks more like a zero or techno one Quote Link to comment Share on other sites More sharing options...
furse Posted March 25, 2012 Author Report Share Posted March 25, 2012 Thats true it was bought off the bay as a rev3 but must be a techno one, the pivots at the engine end cam from a gas gas contact same size spindle so you can use, needle cage bearings, they were too wide and needed turn down a couple of mm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.