Hi

I want to top up or replace the fork oil in my 2014 Sherco ST 125.  Any "How to" videos on the net?

Thanks

Early sherco but basically same to replace your oil without doing the seals .

.http://www.lewisportusa.com/manuals/sherc_11-21-09/sherco_fork_seal_replacement-1.pdf

NNNNNoooooooooo! It is not the same on the Tech forks! They are set by levels.

The right side has the damper unit. Here is the procedure: http://www.shercousa.com/pdfs/Sherco_Fork_Oil_Change.pdf

I presumed he had the settings with him wanting to change the fork oil.But have deleted the post now.i couldn't find your link which i had seen previously.

Getting round to replacing the fork seals in my 2014 Sherco ST 125.

Questions:

1.  The right fork leg is refilled to within 55mm of the top of the fork tube.  Is that with the spring and rod in or out? (Not done this leg yet).

2.  What about the left fork leg?  Spring in or out?  Oil level 55mm as well?

Thanks in anticipation.

Or this from formula the tech forks manufacturer

http://www.rideformula.com/support/downloads/

Edited April 2, 20188 yr by cascao

On 3/30/2017 at 6:41 PM, stpauls said:

Getting round to replacing the fork seals in my 2014 Sherco ST 125.

Questions:

1.  The right fork leg is refilled to within 55mm of the top of the fork tube.  Is that with the spring and rod in or out? (Not done this leg yet).

2.  What about the left fork leg?  Spring in or out?  Oil level 55mm as well?

Thanks in anticipation.

Anytime you see a level quoted it will be with the fork compressed & no spring, rod should be extended as well