westygas270 Posted October 1, 2018 Report Share Posted October 1, 2018 Hi all just wondered what map setting most run there bike on ? Know some people say doesn’t make much difference also what way does the switch go for wet and dry setting ? Also done two small trials on my new bike had about 3/4 of a can of fuel through it and is smoking when you open it up, I’ve not really had it opened up as small trials and knowntge garage put a lot of oil in a full tank of petrol has anyone had similar ? Quote Link to comment Share on other sites More sharing options...
dmc2028372 Posted October 1, 2018 Report Share Posted October 1, 2018 Did you buy it new? Quote Link to comment Share on other sites More sharing options...
sirdabalot Posted October 1, 2018 Report Share Posted October 1, 2018 Switch to — is for wet, O is for dry. Think of the O as the sun (the sun only remains a thought now here in the UK). Your other problem, throw the old petrol mix out and start with a new correct mix. Quote Link to comment Share on other sites More sharing options...
westygas270 Posted October 1, 2018 Author Report Share Posted October 1, 2018 9 minutes ago, dmc2028372 said: Did you buy it new? Yes is new by two small trials Quote Link to comment Share on other sites More sharing options...
westygas270 Posted October 1, 2018 Author Report Share Posted October 1, 2018 Thank you for that Quote Link to comment Share on other sites More sharing options...
gasserguy Posted October 1, 2018 Report Share Posted October 1, 2018 (edited) The user manual has stuff in like mapping switch and lots more. http://trsmotorcyclesuk.com/tech/ Edited October 1, 2018 by gasserguy Quote Link to comment Share on other sites More sharing options...
taff_d Posted October 1, 2018 Report Share Posted October 1, 2018 (edited) TRS recommend only 50cc to 5lts and definitely no more than 60cc 2017 TRS One RR Keihin PWK28 carburetor (all engine sizes) Gasoline - Minimum octane USA – 95 (Ethanol content must be 0%) we recommend race gas, no ethanol Premix ratio – 100:1 (absolutely no richer than 80:1) Float height – 19mm Main jet – 125 Needle – JJH (3rd clip position) Slide size – 3.5 Pilot (slow) jet – 45 Choke (starter) jet – 62 Air screw standard position (factory setting) – 1.5 turns out Edited October 1, 2018 by taff_d Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.