petert

post a pic of the one you need, as I have a brand new unused base gasket that is of no use to me!

That'll be intreesting as they are different! Ask me how I know

mine has 2 bolt holes on the left hand side, on the inside of the Swingarm

Yes it is! However, no one can tell me the thread size! I have established that it uses the earlier 125 engine from a Techno/Gara and ordered parts accordingly but am stuck with the above at the moment. I have mic'd it up and it is 24 point something but knowing my luck I'd buy a 25mm puller and it would be a 24. I'm trying to get a definative answer to avoid ending up with a toolbox full of pullers!

Been a member for a while but lost log in details so had to reregister (age thing no doubt) Anyway, after an 18 year lay off I have taken the plunge and bought a 2000 125 Rev3 to get back into trials. It is proving to be a bit of a bugger to say the least as it appears that early Rev3s are a bit of a bitsa. My problem is that I need to remove the flywheel to change the main seals, however, the 30 x 1.5 puller I have doesn't fit! It appears to be a smaller size and my question is does anyone know the correct size? I have tried Lampkins and they can't remember! But did advise they are no longer available from Beta. Thanks in advance Pete