Divouneh

https://washingtondc.craigslist.org/mld/mcy/d/mount-airy-ossa-mar-250-bultaco-250/7381545325.html Ossa, and 2 Bultaco Alpina for sale.. I love the Ossa 😉

Ready for the adjustments: nothing must move with the nuts ( 3: one in front and two in the back. Next step will be to review the gas tank : liner, painting,...

We are back, I have done the rear fender, tail light and did few things I had to redo by missing spares ... The space is tight on the chain side for brake, chain cover, chain, Shock Absorbers ... Next job: set up the alignment seat/ tank/ frame.

Swimming bike ... Ida went here few days ago.

Same subject: what are you using in the US as liner coating ?

Chain guard in place, time to adjust the fenders: I want to make one with 2 parts. The frame had a long life before me. I will need to bend some supports 😏 to have have all ( seat, fender, gas tank,...) in the same line...

Rear wheel is done 😅, we will see if the bearing repair is working when running. I made some adjustments (grinding) to remove swingarm play 😏, you could see that you have a dirt bike not a race bike 🤫. Next step: back fender and rear tail light...

Just the front light , the complete electrical circuit to be done in 12 volts....

In practice much better what you can see in the picture 😒....

Front wheel is done 🧐... I could start to install the front fender, speedo and brake hardware 🤨. I have in my shelves an old speedo bought for a previous project but never used: I will use it ☺️. https://dcmotive.com/products/dcm-gps-speedometer I am still waiting the compound for the rear wheel bearings 😔

Remember, I said: "The good news is the grease was fresh, bearing was easy to remove 🤨..." One rear bearing is not tight as it must be in the drum. I will ad some retaining compound to prevent any rotation.

Bearings arrived today 😊....

I found this one in Internet...😒

Ignitions for Bultaco: https://boutic.kennedy.fr/view/category/virtuemart_category_id/10.html

Today, swingarm and rear shocks...😆 I will probably start a new post, I can't load any more pictures 🥵..

Hello In my 250 Alpina (115), I am looking to install the rear brake switch in the swingarm... What do you have, pictures ? Thank you Divouneh

Were not bad 🥴...

I removed the front bearings, where not bad 😏... Now waiting for the new set, perhaps Monday 🤥, I have enough job for the weekend 🧐.

The good news is the grease was fresh, bearing was easy to remove 🤨... They need to be tight in the wheel and "loose" in the shaft, I will see with the new one expected for this week-end. Just remember how old is the bike 😬. One needs to be replaced the other one seems ok but will be replaced too.

Rear wheel, seals and bearings are out ...

Yes it's going slowly: I am waiting the SKF ball bearings for the wheels and the tools to remove the old one properly. One from the front wheel is out of order, and without seals ? The front tire is in place, the target is to have both wheels in place by end of the week.

Fork boots arrived, now I can go ahead:

I used: https://www.ebay.com/itm/303132310214 https://www.ebay.com/itm/281880258398 I ordered today dust covers (the one installed were too short)....

Fork is 90% ready ...

Cleaning the fork cups: my springs (13) are dead, I have seen the same size in my ball pen 🤫. It will work 😃...