hightown

Thanks for your reply, That was good advice Hightown

Hello Swoosdave The instruction only told you to line up the Red or Yellow mark on back plate with top fixing screw,it did not tell you the exact timing, Bultaco UK did not know the timing themselves. I am just curious to find out what the timing is? Hightown

I have fitted Electronic ignition to my bultaco sherpa from Bultaco[uk], when you line up the red mark on the back plate with the top fixing screw what would the ignition timing be. Thanking you in advance Hightown

What is the main difference between the Ossa mar 35mm forks compare to the Bultaco Sherpa forks. Is it the size of the holes in the damper. Thanks Hightown

Hi All Any advice on fitting the bultaco oil seals would be appreciated especially unscrewing the nut at the bottom of the fork leg. Regards Eddie/

Hi, Is it difficult to fit bushes to a swinging arm of a bultaco sherpa. Thank you in advance egsmyth

When you fit a heavier flywheel do you need to increase the tick over speed to allow for the extra weight Thanking you in advance Eddie

I would block up the ports that are exposed then fill the cylinder with diesel. Leave it for a couple of days Hope this helps Eddie

Hello Scorpa4banger I had the same problem with my 79 Bultaco 250, It turned out to be the jet at the bottom of the choke chamber was blocked once it was cleaned it starts on the second or third kick . Hope this helps Eddie

Hi I had the same problem with my Bultaco Sherpa 1979 250cc . It had not been used for 22 years, It turned out the jet at the bottom of the choke was blocked. When i cleaned it out it starts on the second or third kick every time, I also keep my throttle closed when starting from cold. Hope this helps Eddie

Hi, I have fitted tubeless tires to my 1979 bultaco shepra. My brother has also fitted them, Mine was a mitchel and he was a dunlop, they were a little tight to fit but have had no problems over 3 yrs. Hope this helps Eddie

Hi All What is the difference between a bultaco Sherpa 198a and a 199a Thanks in advance egsmyth

Has anyone any tips on improving the suspension on the Bultaco Forks. I have seen Fork Tops with air values do they make a difference. What would be the difference using SAE10 oil or SAE20 oil? Thanks egsmyth

I have tired to adjust the clutch so that I have some clearance at the handle bar leaver. It will not clear the plates unless I have no clearance. I have adjusted the nut at the clutch fully in then out 1/2 turn, I also have 18 plates in the clutch basket would this be right, any help would be appreciated Thanks Eddie