zaccyboy

Hi Guys and Gals, The question is.. just acquired a gassa 250 txt pro on a 05. The clutch has been redone about 3 weeks ago by previous owner ( done by shop )The clutch feels very tight at the lever ( pulling lever in). Any ideas on this would be appreciated. thanks all.

Hi TC, Iv been running gas gas txt pro 250 ( 06 )Im thinking of changing to Beta Rev 4 ( 07/8 ) I know the difference between 2 and 4 strokes but I wondering what you guys think? Any advice on the Beta ( running it etc ) would be great. Gas or Beta ?? its over to you guys. Thank You Zac

Hi Scotty and welcome to trials, the woods at pea farm are a good place to start. Nothing to demanding. I often get down there so if you's fancy a trip there give me a bell. Zac 07809375069

Hi Folks, I own a Peugeot 1007 fitted with a Swan neck towbar, Im wanting to fit a bike rack instead of lugging a trailer around, anyone know of a clamp that fits onto the swan neck to allow the fitting of said bike rack. Thanks Folks

Hi, much covered topic, which is the most suitable oil for 2003 beta rev 3.Currently usin SAE 75 THANKS ALL

Billy T - The knocks/clanking is when throttle open, I also wondered if the prob was merely the engine was at its max!!!! I will try higher grade fuel at weekend and keep u posted with the results thanks guys

Hi iv got a beta rev 3 on a 2003, when I put her under load ie up hill climbs the engine knocks, could this be a fuel grade prob or timing? I use unleaded but Iv read that Beta's like a higher grade fuel to run better, any experiences on this? Re timing any views on this? Thanks

Any advice on controlling bike down steepish narrow slopes and banks? I seem to flap abit when atemping these and usually make a complete clown of myself and slide off, which brake to use and body position would be a help to start I guess, also bar and lever position( beta rev 3)would help too. CHEERS GUYS

cracking stuff

Hi mate, Iv tried to find rayc on forums re trials schools in the northeast of england but to no avail, can you point me in the right direction if poss. cheers mate

Hi all, anyone got any info re trials schools in Northeast England, anyone help?

Thanks guys, re tomorrow,I will pm you mate maybe get somemore tips off you at rothbury. thanks again guys

Hi all, Well i entered my first trials today at Consett - Hownsgill Farm, well I was geared up for it,tagged along with another lad to the first section and thats where it all pear shaped lol. I learnt 2 valuable lessons here, 1, spend more time watching riders ride the section and have the bike positioned correctly lol,I did neither of these and that was that lol OFF !! twisted my left knee so that was my entry at trials, but rather than give up I followed the guys around the course and WATCHED..I managed to get an hour and a half on the bike before my knee give up and I was goosed lol. I will try again tomorrow at Rothbury.... this time watching and learning!!! Prior to today I only spend about 2 hours riding over 3 outings on the bike so Im pleased i managed the hour n a half to be honest lol. Any further advice would be very appreciated guys.

Hi Guys, Thank you for your responses, the wrist problem stems from 30 years in martial arts ( old school training methods catching me up lol ) I take the comments re beginners putting to much pressure one the bars which I guess is normal,I will try a wrap on wrist to see if that helps, Iv got a couple of trial events at weekend ( first ones )so I will try to put more weight on the pegs and guide the bike. Thank You all again Respect

Here's a one for you all, Iv just started trails, Iv had bother with my left wrist for a few years,on my mountain bike Iv had to use a riser stem to raise the bars up abit to take the pressure off my wrist ( my left hand can literly fall asleep after awhile) which isnt good lol, could changing the bar postition on my beta help or i can I get a higher lift set of bars? All help much appreciated. Cheers All

hrc_monty I see what you mean re Trails UK how to videos, very good tutorials.

Hi Mate, Post Code is NE65 8JG, Roughly between Rothbury and Scots Gap near Hesleyhurst.Hope this helps.

hi guys, thanks for your advice, much appreciated.

Hi,the pads on my beta rev 3 ( 2003 )need changing, can anyone point me in the right direction and easy to follow instruction on changing them, its been a long while in attempting a task like as iv been out the motorbike sector for years. thank you

Hi all, im Steve from Blyth Northumberland & new to trials, just purchased a Beta Rev 3, so everything trials and bikes are a priority lol, Id appreciate any help,advice and anything else you wanna throw my way to help me on my journey. Regards to all.