[Sherco Side Stand Spring]

Take a zip-tye and tie the centre of the kickstand spring to the kickstand this should give you a tiny bit of clearance.

[Need Opinion From Evo 4T Owners]

Nothing wrong with the paper filters.The Beta does have the availability of the long range kit.The Montesa main clutch has to come off for oil changes to the best of my knowledge.

[Fork Seals For An Evo]

Try Wane's help on the Sherco website.

The Beta forks are very similar.

[Not Reving Out. 240 Rotax.]

Sometimes on the SWM rear exhaust box baffles can come loose.

It is noisy but check without the final exhaust on the bike.

[Beta 4T Carb Needle]

I would like to thank Billy Traynor for helping sort out the carb troubles that I had been having on my 2008 Rev 4t race.

It would appear that most of my problems could be traced to the nylon spacer that is on the needle not being below the needle clip but above the needle clip.The midrange was terrible.Billy also suggested a slightly larger pilot and main jets.It looks like the bike is very close now, only some fine tuning needed.Thank you again for your help Billy.

[Noisy 4Rt Top End Noise]

Peter

I am wondering on the off chance that you may have recently changed oil brands or viscosity.Good luck chasing down this noise.

[Welding On Bike]

Bond all wires together after diconnecting them.Better yet take ignition and all electrics off of the bike.

[Welding On Bike]

Bond all wires together after diconnecting them.Better yet take ignition and all electrics off of the bike.

[ossa 250 gripper jets]

I think you will need a main jet and a pilot jet.

[Organic Pads for Beta?]

Beta p/n 007360718

EBC FA495X

GOLDFREN 282

GALFER 428

These are the cross reference numbers that I am aware of.

reggie