jack_h

there's a little bit of info on all the 08 bikes on todotrial.com

hey, i'd just like to thank andy for an excellent set of high quility photos from the wtc at france. them sections looked really hard. thanks again jack

hello again are any of you lot riding the berko round at nash mills this weekend see you there jack h

27th at nash

just had a look around the berko site and have realised who you are. don't think i'll be out this weekend - going to see if i've fixed the beta at nash instead. are you rider berko rd3? jack h

top ride from antonio in the mx2 class i really need to remember to tape it on chanel 4 on sunday nights

i retired from the last trial after hurting my rib earlier in the week. Ive just got over it and don't want to be knackering it before the berko round on the 27th. if i don't ride im going to go and practice

just had a look round though 165 is a bit far south for our area so could not find it

hey all im riding a trial (weather permiting) this weekend at mathews brickyard ran by the kenton and kingsbury (k&k). Does anyone have directions to the ground. thanks jack

a few clips of kickstart was on channel 4 sunday night - the actors that played the cops from hot fuzz were presenting it. It was only a short clip inbetween other older programmes. a good few years back men and motors did a modern version of kickstart. it used the same theme tune and was even presented by peter pervis

Got the sticker kit last week - look REALLY GOOD on the bike pricey but good, especially if like me you like your bike o look a bit different to everyone else's Agree with you re: the handlebar bit - looks like a dumbell to me... how much was it? got any pics? thanks jack

how much were your plastics heath? i need the bike black before my dad will do the rims

im not really that keen on the black frames. Barry - a while ago on the r2w site there was an article on a red graphics kit to go on the four stroke beta.... do you know what happened to it. cheers jack

hey all im riding an 04 beta and was wondering if anyone has any ideas how i can make it a bit more black. i might do the rims once it doesnt look so red. thanks jack

http://s98.photobucket.com/albums/l255/mud...be%20-APR-2007/ http://s98.photobucket.com/albums/l255/mud...nt=DSC_0021.jpg

hey all im trying to add a photo gallery onto my SITE though am not sure what software to use. Im looking for something free and as easy as possible to install/setup thanks jack

125 don't use Mikuni's do they? Should have a Dellorto carb, the one with the massive idle screw? If it is Dellorto, check your floats aren't sticking on the poles. The tiniest amount of dirt in between the pole and the float will cause it to stick and thus not shut the valve off. I'd also recommend removing your existing float valve, hold it up to the light and see if there is any marks/imperfections etc. The smallest of marks here will allow fuel to bypass the valve. Before you buy anything, strip everything and examine very closely. Get a needle or very fine flat head screwdriver and clean everything! Dan my beta is using the mikuni carb. thanks for the advice jack

i have tried your suggestion of checking the float valve and it does stop the fuel but when the float bowl is back on and you move the carb around fuel is pouring out the bottom hose. with the engine running would some of this fuel be going into the engine and flooding it hence causing the problem. thanks jack

i havn't tried that yet justin though will do tommorow huge thanks lads jack h

hey barry i havn't tried any of your other suggestions. what is the drilling mod? thanks jack

hey all, during my last few trials my beta 125 has been running really rich to the point of it stalling with a fouled up plug. On examination have found that fuel is leaking out the carb when the bike points down hill. I have tried adjusting float level with no success. Does anyone think a new float valve would solve the problem because me and my dad are running out of ideas. thanks jack

the sherco is an 05 and the beta is an 04

top ride from alexz - taking the win on day1

I am having troubles with my beta 125 which we think might be down to the coil could anybody tell me weather i could use the coil from my dads 290 sherco to test if this is the problem. thanks, jack