tugg Posted August 7, 2019 Report Share Posted August 7, 2019 Hi I have acquired a 2013 gasgas 250 and the clutch is not disengaging , I have bled the system and it is still the same , I decided to take the cover off and take a look and couldn't see anything obvious , I I un done the basket but couldn't undo the pressure plates because of the odd size bolts , anyone have any ideas what it could be ,also what size socket or tool fits the pressure plate bolts. cheers Link to comment Share on other sites More sharing options...
nigel dabster Posted August 8, 2019 Report Share Posted August 8, 2019 measure pack height. Link to comment Share on other sites More sharing options...
zippy Posted August 8, 2019 Report Share Posted August 8, 2019 I believe the pressure plate bolts are 6mm - 12 point Link to comment Share on other sites More sharing options...
huski Posted August 8, 2019 Report Share Posted August 8, 2019 Is not disengaging at all,or dragging?Does the fluid level drop,if so I would look at the slave cylinder,if not I would do as Nigel says and check the clutch pack thickness,should be 9.85 mm. Link to comment Share on other sites More sharing options...
anotherfive Posted August 8, 2019 Report Share Posted August 8, 2019 It'll be the centre bolt with hole in it. Hold in clutch as much as possible. Rev engine high and bolt will /should self screw back into place. Otherwise remove cover with bike on its side and tighten centre bolt. Link to comment Share on other sites More sharing options...
lineaway Posted August 8, 2019 Report Share Posted August 8, 2019 12 hours ago, zippy said: I believe the pressure plate bolts are 6mm - 12 point Close 7mm 12pt. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now