throttle cable install on GasGas

[robson]

Hi,

my GasGas 300 came with disconnected throttle cable at the lever, any info how to connect it?

Do I have to open the housing there?

thanks

[UG_ALLSTAR]

If it's a domino throttle then yes. Open the plastic housing via the hex bolts. Hook the ball into the throttle cam and reassemble. Don't overtighten, just snug.

[cleanorbust]

Make aure you test the cable after refitting it by turning the handlebars fully to right and left, engine not running. As you shut the throttle you should hear a click as the slide bottoms in the carburettor. If you don't hear this, you need to dial in a little slack on the cable with the adjuster on top of the carb. If the cable isn't bottoming properly the engine revs will race on start-up.

[robson]

Below on the pics is the TB Domino housing what I'm asking about,  is there a cover I can pop up or unscrew everything?

[faussy]

No need to take the hex bolts out. Pull up on the tab just to the left of the d in 'domino'.

[robson]

8 hours ago, faussy said:

No need to take the hex bolts out. Pull up on the tab just to the left of the d in 'domino'.

are you sure i won't break it?  

[tony27]

The cover is meant to just clip in place, close the throttle & fit the cable with the last piece to go in being the outer casing into the housing. Test that the cable is working properly before refitting the cover