lemur Posted Saturday at 06:03 PM Report Share Posted Saturday at 06:03 PM In theory; your piston wobbled because of either tightness in the wrist pin bearing or a jam sandwich in the piston rings. Quote Link to comment Share on other sites More sharing options...
jrsunt Posted Saturday at 11:10 PM Report Share Posted Saturday at 11:10 PM (edited) I’d be checking the internal diameter of the con rod small end. Even with the slightest play it will give a knocking noise. The piston doesn’t do much other than support the rings, which do all the hard work and wear considerably. If the con rod is slightly out of specification everything will wear as it won’t be runnng true and it will do the same again Edited Saturday at 11:22 PM by jrsunt Quote Link to comment Share on other sites More sharing options...
bobb Posted yesterday at 10:54 AM Author Report Share Posted yesterday at 10:54 AM Lemur what do you mean with jam sandwich? Quote Link to comment Share on other sites More sharing options...
lemur Posted yesterday at 02:10 PM Report Share Posted yesterday at 02:10 PM 3 hours ago, bobb said: Lemur what do you mean with jam sandwich? When a piston ring pack becomes gummed up from bad fuel the rings stick in the piston grooves, then everything starts to go badly. Once you experience it you will know why I call it a jam sandwich. Quote Link to comment Share on other sites More sharing options...
eagle8 Posted 16 hours ago Report Share Posted 16 hours ago On 12/20/2025 at 9:02 AM, lemur said: You sure you want to hone a plated barrel 🤔 don't think you are suppose to do that. I've had a few plated dirtbikes & have given them a light hone before installing a new piston & rings, i know a lot of other Blokes that have done the same, as long as the mechanic has the correct tool & knows what he is doing there should be no problems. Quote Link to comment Share on other sites More sharing options...
lemur Posted 1 hour ago Report Share Posted 1 hour ago 14 hours ago, eagle8 said: I've had a few plated dirtbikes & have given them a light hone before installing a new piston & rings, i know a lot of other Blokes that have done the same, as long as the mechanic has the correct tool & knows what he is doing there should be no problems. So you are scratching up your fresh new spray coat of ultra hard nickel and silicon carbide that is actually harder then your piston rings for what purpose 🤔 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.