Vertigo

Thought this might interest the vertigo peeps: https://trials.com.au/news/ep-54-dougie-lampkin--the-champion-ambassador-legend-5456

Any idea of how change rear brake fluid whitout remove mid bike?

Hi guys I’ve recently had a 2017 ice hell, I was just wondering what the sag is like on your bike guys? bike on paddock stand rear wheel off the deck I can lift the rear wheel a few inches but the motion feels very loose like a bolt has snapped or the sleeves in the linkage by rear shock have worn, anyone else noticed this?

After doing a ride at altitude this past weekend, now back at normal riding level I am finding my bike will just stall if sitting at idle. My partner's bike is doing the same. it's like I now always need to have a little bit of throttle on to keep the bike from dying. It also seems a little less powerful at the lower revs but that could just be my imagination. Bikes are 21 R3 and 22 JBR

Bonjour. If this is possible, could you give me a copy of the manual for the Vertigo 250 from 2020. I have some concerns. Thank you. Great site

Workshop manual 2016 vertigo 300 combat required thanks

Hi there ive just recently bought a new vertigo and managed to find this manual for anyone to look at cheers Andy parts_book_combat_titanium_rr_works_250cc_2017.pdf Vertigo titanium_r_manual_2017.pdf

Hi everyone, I've pulled the gear cassette to replace the kick start gears. That's all sorted but I noticed the shift sensor magnet is free to spin on the shift drum. Surely this can't be right? Any help is greatly appreciated. If anyone has a workshop manual it would be ver helpful!

I need new footpegs for a Vertigo Nitro 250 2022. Any recommendations?

My 2022 Vertigo Nitro JB replica with battery, is extremely difficult to start. As the temperature drops more kicks are required to start it. In the garage at 10c it took 70 kicks to start it. Battery is good 13.3 volts, throttle body just cleaned and mass air flow cleaned, new plug. Took so long I thought it was broken. Suggestions please.

Is this kickstart shaft the same as V-0231 – KICKSTART SHAFT? I'm having trouble getting the parts to fit together properly. My bike is a 2019 Vertigo Vertical Combat 250cc, and I'm using the original Vertigo kickstart lever. However, I can't seem to get it to fit correctly onto the shaft. I was expecting there to be a groove or slot in the shaft for the cross bolt on the lever to lock into, but it doesn't seem to be there.

Where can I buy a rear shock protector (rubber flap type) for my 2020 300c Dougie Lampkin vertigo? Or what do you use? Please advice,, Im new to trials. Thanks in advance

Hi I’ve just bought a 2016 combat 300 that won’t currently start (bought with an intermittent starting issue). What does the powerbox part number V-0533 do within the ignition system? thanks

Hello, could you tell me what could be the problem with starting a cold engine? I have to put the bike on a stand and kick it as hard as I can about 20 times. After starting, the bike starts right after turning off the engine, but if it sits for 2 minutes, it is very difficult to start again, sometimes even impossible. The bike has a lot of mileage (about 1000 engine hours). After purchasing it from the previous owner, I replaced the fuel filter, fuel pump, injector, hose clamps in the gas tank, ignition coil and condenser in an attempt to find the problem. After that, everything got better, but the problem remains. Direct fuel injection into the intake manifold helps; in…

Hi everyone, new to the forum so hopefully I've posted this in the correct place. I'm also new to the Vertigo club and unfortunately, I've had nothing but trouble with it. Initially it had a faulty relay, which prevented the fan coming on, and the bike over heated, boiling off a lot of coolant. I changed all 3 relays just to be on the safe side, problem solved. Ironically, now the fan is on too much. Once the bike gets up to temp, the fan comes on and doesn't turn off - So much so, that I think it's causing the battery to drain. (it's brand new and already down to 2/6 bars) I can probably add 40 - 60ml of coolant after every ride. I must have d…