bondy

i will put more photos on when the weather is better. ???????????????????

198A

sorted it at long last hears the 198A

198A is finished guys sorry for some reason i can't up load any photos. ill keep trying. i can't down load photos from my phone to the lap top so ill try something else to see if it works.

Ah ah

alloy tank back from paint and is finely on the bike with seat.sorry trying to down load photos off the bike but having no joy.

198a

you shouldn't need to mod it just strip the fork and service them with new springs and oil. if it's wobbles the head stock bearings need changing or the top yoke nut needs tightening or the front wheel.

198A now finished

the 198A is now finished tank and seat are on enjoy

if the chain tensioner is sticking try to slacken the bolt off if it's not that may be the spring or the tensioner it catching on something. another thing is with the chain tenstoner where the rubber block bolts on put the small nuts on the out side with the sloted side to the wheel this way theres no chance off the bolts rubbing on the tyre.

i have same mudguard stays on my 199B in blue they lift the guard high. i would try to losen all the syay bolts and from the rear off the guard puss up and forward. and at the same time tighten the rear bolts then the front this should raise the guard up a little bit. those stays look like sammy miller stay with the 1 fixing hole on top. they normally don't cause any problems they should raise the guard up high. as for the chain ajust with snail cams or take a link out. it should be set so you can get your thumb between the chain tensioner. and the S/Arm also both snail cams should be set the same. not having ago just trying to help you.

lovely bike mate always wanted a red 1

cheers breagh it should look alot better once the tank andvseats on it. Its only had about an hours run in

Hello I had a 350 barrel hellicoiled worked ok but I had to get it done again. It draged the coil out when I took the head off. I snaped 1off the studs off the bottom end had to have it drilled out and hellicoiled. That did work fine.

Before

Hello this is the before and after the 198A restore.

198B ready to ride.

Hello i fitted 1 ages ago easy.

Hi stanley yes the bike is nearly finished just waiting for tank to br painted at the pai t shop then its finished i will post photos when its done.

hello sanley yes there is some on hear look under 198A rebuild and you will see my bike.

am waiting for my tank from paint then its all done and put the seat on also. am not sure what am doing with it yet as its road registered in my name. i have the number plate when i bought it last year it was still on the road. but as i have not passed my bike test its a no go for now but i do intend to go in for the test. i would just have it on a day time MOT

nice 1 glad you got there mate keep us up dated.

buy new ones

as above make sure the earth is connected to bare metal not painted. on my 198A i just had painted where the HT coil mounts i sanded half of that back to bare metal. then the green wire with a loop terminal connected to the wire i bolt it onto the HT coil.