ducati996

Thanks,

Anybody know if u can get after market gear lever for beta 80 evo or do u have to pay

Had same problem on gas gas 280 cracked from shaft to clutch cover bolt,hell of a job to weld as they r alloy/magnesium,think its down to wear on quadrant/pinion give Trials UK a ring they will advise you.

Dont think u can get a pattern bearing think yamaha have us over a barrell, was told yamaha tzr 250 r bearing was the same so phoned fowlers up & price was exactly the same. Managed to break rear brake pipe joint when removing engine from frame scorpa want £47 for new braided pipe found 1 on ebay for pit bike exactly the same but about 1 ins longer brand new with p+p £9.99

Apparently u can still use head gasket as long as u not cooked engine,clutch cover gasket £20 were do the get these prices from its only cardboard,does mean however that my cornflakes box must b worth £40 as i should get 2 gaskets out of it & it comes full of cornflakes. Going back to the bearing the play is very small u can barely notice it thats why i was hoping to get away with just bearing if a small end bearing went u wouldnt change the rod so whats the difference apart from the size of the two jobs. .

because its a lot cheaper & its the only thing thats worn conrod kit £200 +,probably put new crank pin in ,apparently big end bearing is made specifically for yamaha hence the expensive price £63 mains r only £13 each head gasket £69 plus vat crazy

just big end bearing u can buy it seperate about £50 seems a lot of money for cage needle bearing was hoping to get part number & see if i can get it cheaper with a bearing supplier

HI,DOES ANYBODY KNOW WHAT THE BIG END BEARING PART NUMBER IS FOR SCORPA SY 250,BEARING NUMBER NOT SCORPA PART NUMBER

yes it did have marzzochi forks 2010 Gas Gas

i had same problem last wk with gas gas 125 where slider came out & left seal behind i gently tapped screwdriver between seal & fork leg because seal was plastic i managed to bend seal & lever out

Good for u ben for standing up for u self lets hope others follow maybe then the ACU will listen

hi,we put bar ends on our beta evo 80 ,as u say they r 2 large we filed them 2 fit,takes a while 2 do but can b done

Hi,on the beta 80 evo the washer is on outside of spacer opposite side to caliper,between spacer & fork leg