jtlaw1

Charlie is talking about american enduros . the world enduro stuff all the checks are known controls (you can get to the check ahead of time and rest then go in on your minute the special test's you are timed from point A to point B . http://www.fim.ch/en/default.asp?item=29# fim rules

Turn it upside down in the sink squirt some shampo in it rub it in to the liner fill it up with water dump it out , do it 2 or 3 times till smell is gone than take a big towel and stuff it in the helmet get most of the water out .

Homer made the big time.

Cody

high over the GasGas camp.

I got about 350 photos and about 4 hours of tape.

Torco race gas is only about $4.00 per gal in this part of the country .

The same puller fits my ktm and husky.

Thay are the same

The mineral oil orings are green if you used the green orings and put dot4 in it the orings will swell.

Look what is on ebay http://cgi.ebay.com/ebaymotors/ws/eBayISAP...7963765203&rd=1 a Garelli jersey.

I got the gas cap at from Lewisport , also some KTM 's take the same gas cap as the sherco because the gas tanks are both made by acerbis and there is a lot of aftermarket billet gas for KTM's. I would like to know who makes the aftermarket top tripleclamp if you can find out.

I got them from the Tryals Shop ,It is a scorpa bar clamp.

I put them on my sons Sherco with the 99/00 top clamp.

This is a sticker on the back of my trailer .

This is the pro. Both 2002 from GasGas web site.

The 2002 pro did not have the same frame as the txt. This is the txt.

Most are made of steel.

The best way to clean the core is to burn of all the carbon with a torch it turns to ash and then use a wire brush . I just did this to a muffler i got of ebay it was `so bad you could tell it had the little hole in it.

Will the gas gas top clamp fit on a sherco? I want to put fat bars on a sherco to.

I did not say it was you. this guy did not have on that flower shirt

I was just f**ing with you . My group was at the easy rider section for a long time and got a good spot to see the top riders and some ahole with a press pass slips under the ribon and stands up in front of us blocking are view it p****d off alot of guys . When that guy tryed to step back over the tape my kid pulled up on it and triped the jerk .

Get a 99or 2000 top clamp or take the top clamp to a machine shop and have them mill off the bar clamp part then you can use the gas gas type.

For that price buy it .