markg

You can still buy new from Honda. Only way to guarantee a good fit in my opinion.

Hi, Thanks for reply, Why do say not possible? The shocks are easily dismantled and seals available?

Has anyone ever rebuilt the rear Marzocchi rear shocks on an Italjet? Looking for oil quantities and any tips. Thanks!

Thanks, I understood the post and that the bearing separates. So your saying to use this type of bearing in both cases or just in the clutch side case? Using the normal bearing in the flywheel side as the gearbox is assembled in this side? or alternatively assemble crank in clutch side case with normal bearing then lower this as an assembly in flywheel case that has the nj205 bearing installed? Sorry if the seems a silly question,,,just trying to get my head around it ..

Hi, a bit confused how using this bearing makes it easier to assemble cases? - the bearing nj 205 ecp c3 goes into the ignition side case? So does this mean the crank is installed into the clutch side case first? any help appreciated.,

Hi, yes my M27 is all running and never touched since it left the factory.

Hi, i have an original M27 but doesn’t have metal badges. Might have been an early production piece that got changed on later M27’s.

Moto SWM in England just sent an email out saying that they had some made.

Actually looking for big and small end bearing numbers not mains. But that parts diagram is great, Thanks!

Hi all, does anyone have the bearing numbers and or sizes for the big end bearing and little end bearing for a Piuma 350? thanks,

Motoplat ignition

Thanks Fourex! I’ll try my Bully puller first.

Hi, anyone know the dimensions and thread size for the flywheel puller on a 350?

Thanks that’s a god start

I thought I read it on here also but can’t seem to find it now.

Does anyone have the colour code or number for the green in the Piuma frame?

Marzoochi front and rear and silver wheels I believe.

Thanks, I’ll try the Hell team. I have read a lot of posts saying the old gasser kickstarts fit but can’t find a model and year mentioned.

-/ Does anyone know the year and model of Gas Gas Kickstarter that fits onto the Italjet’s? And maybe a supplier? -/ are kickstarts shaft still unobtainable? thanks, - mark g

Does that cap in the listing actually fit? I am in need of a cap also.

Names or websites of any companies would be great! I have enquired many places here and abroad and no one can help,,, or can be bothered.

Contacted Banjeres with no luck on rings just the bare piston. Hence the need for someone to make rings.

Yep, it is a 260cc TLM. I have searched catalogues for something similar but nothing as yet. I can get a genuine Honda piston at an expense but no rings. I matched up a conrod but the crank pin is too short so need to get one made and as yet no one is capable. Cost is a problem but want to get this bike going so have pay to play....

I had a look at that site but couldn’t see any pistons.

Hi, Does anyone have any contacts for getting rings made. I am chasing some oversize rings for a 1990 TLM 260.