reggie
-
Posts
349 -
Joined
-
Last visited
1 Follower
|
|
Contact Information
-
try closing the spark plug gap to approx. 0.35mm I am assuming you have tried a NEW spark plug
-
You may get some better answers if you post a birds eye photo on this forum.
-
What colour is the plastic that surrounds the fuel cap ? It looks like it may not have been modded.
-
I believe the fibre clutch plates that look like that were made by " hoerbiger "
-
Where have all the old txt gaskets n orings gone??
reggie replied to Creepytheclutchmaster's topic in Gas Gas
Find the parts book you need online ( this took me less than 5 minutes ) figure out what part numbers you need, then search for each part by number This is not the easiest but you should find what you need. Good luck. -
Lemur, I hope you heal up quickly. Cheers Reggie
-
Beta Evo 250 Factory (2021) stalls, and doesn’t start
reggie replied to rottarbence's topic in General Trials Talk
One thing I would check is after you put the float bowl back on to the carb, make sure you can hear the float assembly rattle when you shake the carb it is possible to have the float assembly to hang up on the overflow tube -
Tech supposedly makes a shock to fit the Gold model TRS
-
Do you mean kick start idler gear ? FYI there are not a lot of engine parts shared between the Evo 4t and Evo 2t
-
I have it on good authority that the fork seals fit.
-
I am pretty that there was not a 300cc GasGas in 2001
-
Take the clutch lever off and see if the issue persists.
-
Those parts do spin, but usually not easily. I believe these are the same forks as were on the Beta Zero / Gara from 1991 to 1993. I am pretty sure they were also on some GasGas bikes in 1993.
-
Take off the header pipe off and measure the bore 72.5mm for 250 if my memory is any good
-
I believe the stock carb for the 1974 TY250 was a Teikei Y26P
