Jump to content

helm

Members
 View Profile  See their activity

  • Posts

    68

  • Joined

  • Last visited

 Content Type 

Everything posted by helm
 
 
  1. helm
    Hi pipe should feed in from the front fairly easily, disconnect the original condensor and remove it use any car type condensor the only criteria i look for is that it already has a bracket on it as i'm to lazy to make one cheers helm
  2. helm
    Hi pipe should feed in from the front fairly easily, disconnect the original condensor and remove it use any car type condensor the only criteria i look for is that it already has a bracket on it as i'm to lazy to make one cheers helm
  3. helm

    Cota 247 Gasket

    helm replied to dave dix's topic in Twinshock

    Hi 247'348 and 349 do not use head caskets or sealant just torque the heads down evenly to the correct settings ,I have had no problems with the heads atall cheers helm
  4. helm

    Bantam Evil-bay

    helm replied to b40rt's topic in Pre-65 Bikes

    Hi wayne tried to post article on here but can't if you want to send me your e mail address i can send you the article direct cheers helm
  5. helm

    Bantam Evil-bay

    helm replied to b40rt's topic in Pre-65 Bikes

    Hi I've got a classic bike mag with an article on the renovation of one of the works bantams from about 1966/67 it states that the works engines had the number red 1 ,2,3 ...three engines the red is apparently short for reditch and these where the developement bike for the replacement for the C15 if i can find the article I'll try and post it here cheers helm
  6. helm
    Hi front brake plate looks like a beamish back one not a beamish more like a ts suzuki cheers helm
  7. helm
    Hi do you have a decompressor fitted? on mine when I brought it and got it running for the first time in at least ten years there was a noise you could describe as a"chirp" this was caused by the decompressor a) the cable binding on release and b)not closing completly whith the cable removed you will need to take it off completly to clean it, with out the decompressor you will find it hard to get over TDC easier to check than splitting the engine cheers helm
  8. helm
    Hi again worked that time (always better when I can find my glasses) good feature cheers helm
  9. helm
    Hi same problem as ed also if you try to access "model" also wont let me post photos ---sorry its posted 3 times trying to put photo on cheers helm
  10. helm
    Hi why not go for the 22Occ Big Bore KIt try stuart at BPS contact details on the honda trials site http://www.honda-trials.com/_sgg/f10000.htm cheers helm
  11. helm
    hi if you look at the photos of JR and CS the front forks are different jr has the much lighter works type there where only 6 works engines with lots of magnesium there are lots of photos in the bernie schrieber training book and also film on the mick andrews training film the original suzuki works frames (2 of )were not used for long as they where very light and prone to bending I would try contacting Nigel birkett as he should know most and I believe still rates the works engines! cheers helm
  12. helm
    hi you can get carbon fibre bash plates from stuart at BPS in france 0033 687383530 cheers helmet
  13. helm
    Hi 50:1with synthetic 2 stroke oil 300cc in clutch and 900cc in the gearbox just drain and replace
  14. helm

    Tlr 200 More Power

    helm replied to mattylad's topic in Honda

    Hi Mattylad you can get a 22O kit (piston and liner) for
 
×
  • Create New...