Gas Gas

Hello all. First post here. I am picking up a 2017 280 TXT later this week. It’s been ridden by a club pro level rider the last couple of years and It’s in pretty good shape all things considered. I’ve been doing a lot of reading on here but had a couple questions: fan - it’s still working but it appears all 4 bolts that mount it to the radiator have stripped out. It’s now just wedged in there. I don’t think it’s going anywhere - but is there a way to drill out and re tap or do folks just go to zip ties if this happens? starting - it’s a bear to start - any tricks or tips here? The current owner claims if you really snap your kick and give it a bit of gas…

Hi. Does anyone know which side the fattest space goes on rear wheel. Mine had it on the sprocket side but the brake disc is rubbing the right side of caliper so was thinking previous owner may have put them in wrong way around

Hi there, had several trials biked in the past mostly 4t, but recently bought gas gas 2006 non runner no spark, checked basics kill switch, plug, did test wiring non appeared broken, looked at fly wheel, elongated groove in it, should there be anything in the groove to create spark ?? I have replaced rectifier not sure how to check ducati coil cdi, Thanks in advance,,,

Hi my 2003 280 had a 90° nipple coming out the left side crankcase which is broke off. I see i can get a replacement but wondering what the best way to remove the old and install the new?

Hi there I have noticed when riding over obstacles that my forks are way too soft and notchy but I'm only 74kgs so its not my weight, and I suspect that the fork springs are worn, does anyone know where I can buy a new pair please help. p.s the old springs are 38mm in diameter

Hi First post here. Thanks for having me. Does anyone know where I can get reasonably priced standard graphics for 2017 300 TXT. In the UK Thanks

Water in gearbox oil

Anyone know if a set of graphics from a 2017 txt pro will fit a 2012 txt pro? Thanks

Morning all. Embarrassing confession on this one...for some reason I used mineral clutch fluid when I was bleeding my brake systems a couple of weeks ago. Life has since got in the way and I only got back in the garage yesterday to put dot4 through. However now there is absolutely no pressure in my front system. Do I just need to persist/get a syringe on it, or will the mineral fluid have damaged any of the components? Cheers Rob

Can someone clarify how many gears my 1993 gasgas 125 trials has please. I had the gear shaft replaced before I ever rode it. I can only go up to third. Does it only have three?.

whats the best oils or the gas gas 250, i think the guy i bought the bike from said putolene

02 Gasgas txt Pro 280; Please can any one tell me what is the forward allen bolt 8x20 in the bash plate for? In front of the oil drain plug. Is it holding something ? Is it to decompress something or to drain something ( water / moisture from fly wheel area) Im not aware of ? Nothing in the manual. only bolt the length. Thanks Tim

Hi, can anyone tell me if clutch rattle on a 2018 gas gas is normal and what’s the best gearbox oil to use and how much ? Thanks

Hi all new to trialscentral so please bear with! Currently ride a pretty beaten up 2000 Gasser 280 txt pro and fancy something a bit newer. Found an apparent 05 model but I’m a bit dubious on whether it is what matey says it is. The livery seems to be from a Raga edition but pretty convinced they’ve been put on after. Also from what I can see the frame seems to look like a pre 05 model wondered if anyone can shed any light on what I’m actually looking at? cheers Lewis

I recently changed the seals on txt pro but the od of the seals supplied are undersize. They seemed to fit ok The od should have been 52.2mm but the ones supplied are 52.0mm, they don’t seem to be leaking but I’ve not done a trial yet! Anyone else had this issue, I don’t fancy wasting the oil to change them

Hi there just wondering if anyone can help me with this. I have a 2002 Gas Gas txt pro which has a V5 so I have a number plate for it and technically it could go on the road. Although I can’t for the life of me see how it would get through an MOT. Did these bikes come with indicators and brake lights originally. I’ve had a look at a wiring diagram for the bike and it just shows one wire that it says to cut if you want to remove the lights Any help with this would be grand thanks

Hi, I have a gas gas txt pro racing 2013. When a engage the clutch it starts vibratin. You can feel it in your backwheel. Clutch feels good no drag of weird sounds. Finger height is good anyone any ideas? I use putoline light gear oil! Greetz Clanned

I need help please this clutch was frozen and when i dissatisfied it i lost the order of the clutch bearing and my setup seems like it has a extra washer that's not in the parts manual. The manual has a ridged washer that rides on the fingers then the bearing. Mine has a extra shown in the attached picture.

My gas gas txt 250 pro tailpipe is in pieces, and can't seem to find any replacement online. Are there no aftermarket makes for these?

Hi all, Currently doing a bit of work on my 2017 250 gas gas I bought earlier in the year. I have done the rear wheel bearings and now onto the front, but struggling on how to drive the bearings out. There is no lip to get any purchase on I read on here the 1p trick for the rear bearings which worked a treat, but can't find anything in the front. Thanks for your help! Rob