Montesa

Right Wonder Boy has found his problem Number 34 on the sheet ( i found it when i was putting the carb back in the bike but put it in my pocket) lucky i never put it in the bin

Right have said my stator might be going so i have to take off the left hand side cover off the engine. But my question is can i brake the seal ( you know the metal cover and the a seal that goes all the way round and the the engine block). So if i take the cover off can i re-use it, will i be ok if i put the cover back on with the same seal, or will i have to get a new seal. Gavin

I just visited the sherco pages and people say that the sherco air box is really bad, i remember this on a Montesa aswell, does water get into all montesa airboxes or is it just when riding through deep water etc.... Cheers in advance

right here is my list 1- I have just cleaned out the airbox and carb to make sure there is no dirt of water about. When i went to start the bike i was riding along and if keeped jumping (every time it ticked over). Also i would not rev out right felt like it was chocking and would not chande gear very well. 2-When the bike is in nutrual when you try to push it is very hard like i fells like it is in gear. But when you pull is backwards it is easy. (why is this). Gavin

Hi I have heard people saying the '99 montesa have poor carbretors What i want to know is what is wrong with '99 montesa carbs? Cheers dan

hi all How much better is a '03/'02 montesa compaired to a '99 montesa? Cheers Dan

I was just looking at Trials source.com If you look at their bike model info stuff, it says that the 2004 Montesa is DEFINATELY the last 2 stroke that they will make. Is it true??...Of course it was sure there is a four stroke imminent...but I thought they might continue making the 2 stroke alongside for a while??

Had a question put to me the other day, and want to see what you lot know, if you were to leave a plate or two out of the clutch pack, would it make it softer ??? Don't go slating me, i was just curiuos what the result would be. I personally have no problem with mine (being a Haven pack). Gaff.

Does anyone out there have any idea how i could smooth out the low down power of my trusty mont. It's a 99 with a 2002 carb on it (cos the 99 carb was a bit of a joke). At the moment the carb is as it came out of the box, and the bike runs a lot better than it did with the old carb. I had a shot of a 2003 model and it was sooo much smoother, power delivery wise than mine. I don't expect miracles, but i was wondering if i could do anything with what i've got, carb wise to improve matters (other than buy a 2003). . Any ideas anyone??

How much oil does a '98 Montesa hold in the case?

can you just tape up the vent holes in the seat or are they requires for air intake? - i have fine mesh on them but it just gets clogged up with muck, figured i'd be just as well blocking them off and protecting the intake from crud a bit

Any idea what the extra carb needle that came with the bike is for and when it should be used? I looked all over the owners manual and it has no mention. This is on an 04 Montesa. Thanks, Bill.

Hi all, does anyone know how long the engine should run for before the radiator fan kicks in. I suspect that mine isn't working. Or is there an easy way of checking that the thermostat is working 'without tearing the bike to bits i.e bridging wires etc. Thanks in advance.

Hi All: After sending my rear showa shock for servicing (changed oil, internal cleaning etc..), I

Hi all: What is the recommended SAE and oil brand for the SHOWA rear shock, I

One complete set of Fujinami replica plastics for sale, Rear Mudguard Front Mudguard and Fork Stay Carbon Fibre style petrol tank (Standard Tank) including petrol tap and all bushes with tank. Good condition - just one slight scratch on the rear mudguard Bargain at

Does anyone know if the 2003's footrests were a little lower and more rearward than previous models, or was that just a one-off mod. on Dougies bike?. I'm sure I remember somebody selling aftermarket footrest hangers modded to give that position, any ideas?.

I notice on the montesa I just purchased that two bolt/stoppers are not on the headstock, they keep the fork tree from slamming the frame. Should they be there or do you remove them for tighter turns? sam

Hi, 1999 Mont. My front suspension bottoms out rather easily. The front is a tad soft. The pre-load is screwed fully down. I'm no heavyweight. I asked Sandifords if perhaps my front spring was getting weak.....however, I did mention to them that the pre-load has always needed to be well screwed in....even from brand new. They said perhaps the wrong weight oil was in the forks which can have the effect I am getting. They said to put in 10wt oil. Comments? I had originally intended to replace the spring, or make up a small spacer of my own to fit on top of the spring. Anyways, I finally got around to ordering some much needed parts for my Mont:- New tyre Set of A…

I'am the proud owner of a barely used 03 Montesa. Would like to know what gaurds you may have found to be worth the money? I see there is long fork gaurds and short fork gaurds, aluminum ones and carbonfiber. Also, case covers, head pipe protectors and so on. The gaurd for a thrown chain looks like money well spent. Please list any more Ideas and also dealers who carry these Items and stock parts. This machine is scratchless, I'am really having a hard time wanting to ride it, I'am in the (stare at it stage of ownership). Sam