Suzuki/Beamish

I know it's been asked before but not seen an answer. I recently put an OKO carb on my Cota with great results and was thinking about doing the same on my Beamish. Has anyone done this and what were the results ? cheers

I have a1975 RL250 I reconditioned several years ago. In the process I needed a new petcock due to leaking past the on/off position, plus leaking around the petcock on/off lever. I originally found a supposed OEM petcock from Partzilla I believe it was, and it worked but the location where the gas line connected sat lower than the original and since it exited out the back the line hits the throttle cable on the carb so a pretty extreme angle on the gas line is needed, so much so that it partially kinks the gas line. Since it is threaded, and the body of the petcock can be rotated, I had just turned it to miss the throttle cable. The trouble with that is it puts the lev…

My 74 RL250 was getting a bit noisy so I took the piston and cylinder off to see how things looked. The crank looks fine and I cannot feel any play in the crank or rod bearings. The piston had a crack on both sides that runs straight up from the piston pin - but the crack is tiny and doesn't go too far up the piston. I cleaned the piston and cylinder and a 0.009" feeler gauge slips in easily and a 0.010" is snug - I doubt if I could get a 0.011" gauge in without a good amount of force. The piston is the stock 70mm size. I ran a hone in the cyclinder and it is obvious there is some uneven wear as there were high and low spots as indicated by the uneven honing marks. …

Anyone know where i could get a stator cover for a black engine 325

Has anyone got a spacer for the non brake side for front wheel or can anyone make one from dimensions of their own, I have either lost mine or didn't realise I had not received it when I bought the suzuki front end. Also has anyone machined off the normal handlebar (i.e. tiller type position) and put clamps on in a more modern position ?

Hi all, i have a 1981 black engine model and am upgrading it a bit, new shocks, footrests, chain and sprockets etc. I want to get rid of the original 'Cow horn' bars. They have a massive rise on them, my question is what sort of rise should i go for on some renthals. I am tall at 6,3... any advice greatfully accepted and see you at fort william on Friday if you are there!! Dan

Where can I purchase the correct brass air valve assembly for a beamish? On the bike I

has anyone any more pics of the silver engine RL250Y with the yellow and black seat as on the later black engine mods. which followed the RL250A that was in red / black ?

Does anyone have a wiring diagram for an RL250 with the light kit? Thanks, Redbug2