|
-
-
Why did'nt you try it first with the 3mm base spacer , before cutting the piston down ?????
-
http://cgi.ebay.co.uk/MERLIN-TRIAL-FIUS-35...=item27af7f1bf1
-
http://www.pyramid-parts.com/advanced_sear...mp;inc_subcat=1
-
Not sure Wayne , but you missed a cracking day out ..........
-
-
-
Hi All
A few photos of a clutch extension arm for the fantic engine ( cheers for that Peter ) . Its made the clutch is a lot lighter.............
-
2 more merlins Click here & here
-
Telford bike show 2009 Click Here
-
Anybody know if its on again over xmas ??????
-
-
Hi
I'm running silkolene light gear oil , which i change every 5 trials ,i have a spare engine clutch arm which can be chopped and extended if anybody as more info ,i'm pretty sure this is the way to go for a
lighter clutch action .....
-
Hi All
How long can i lenghten the engine clutch arm on a 125 pro twin shock (very similar to the 240 pro) to make the clutch lighter . Also as anybody got any photos of the set up ????? Cheers Merry Xmas
-
-
I again
Does anyone know if the older minarelli 200 barrel and pistons (156cc) fit on the later fantic motor 201 (156cc) or are they completly different .......
-
One for you fantic experts , whats the difference between the minarelli 200 (156cc) and the later fantic mono 201 (156cc) barrel and pistons . Cheeeeers
-
Hi again , i've just took the head off a spare 199a 325cc engine i have , and this is as high as the piston goes with no base gaskets .The 199b 340 i have as a raised liner but its still the same with the piston top near flush with top of the liner ...Cheers
-
Click here http://cgi.ebay.com/28mm-Mikuni-Carburetor...id=p3286.c0.m14
-
Hi again ,are you sure your using a bultaco piston ??????
-
You should'nt really have trouble finding the correct piston for a sherpa t ( bultaco uk or hughes if your in the USA ).In my case my 340 199B was on its last rebore and i needed a 86mm , the mahle piston i purchased may of been for a frontera or pursang . I think i took about 5-6mm off the skirts to match my original one . If your in the uk ring bultaco uk Dave renham is always helpful and knows his stuff ......
-
Hi there , i had the same problem with my 199b 340 , i had to get the mahle piston because it was the only 86mm one i could find. I just trimmed down both skirts to match my old piston ....
-
Hi everyone
Does anyone know the crank oil seal sizes for a 32a engine ?????? ...Thanks in advance
-
Hi everyone
I'm considering putting some alloy rims on my sprite ,other than new ones does anyone no of any jap bike that where fitted with 40 hole rims ,so i can keep a look out for some ...Many thanks
-
Hi everyone
I've just bought a sprite trials bike , i think its 1965 ish , as anybody got any info about these bikes ( engine spec , how much oil in the forks etc ) .....Many thanks
|
|