Hi
Yes you push the piston on I use a piece of wooden dwell but you can use a screwdriver.
Same technique open nipple push in close nipple.
I also place a peace of wood 12mm wide in between the pads to stop the pots coming out to far.
Hi
I can tell you the caliper needs to be at the lowest point i know it seems strange but it works.
Normally I would bleed then hold the lever in over night allowing air to travel up.
Working on bikes can be both rewarding and frustrating at the same time
Hi
I had the same problem. The pipe goes up then down on the bike and its hard to remove all the air
It is easier to remove all the brake system and bleed on your bench hold the piston higher than the caliper.
Once bleed refit.
Hi
Had one as my first bike, people told me to powerful for a novice but it all depends upon how much you twist the throttle.
it depends on where you are going to ride as it can pull your arms out.
As with old bikes some parts are getting hard to find.
It seems to be a little pricey.
Hi all
Looking for help I have a 1996 250
The fork seals have gone and I am looking for information on the seal sizes as there seams to be conflicting sizes on the web.
Looking forward to your reply
Wayne
Hi
There are plenty of clubs around you , look at Acu Midlands wed site.
There's a trial most weekends
Most club trials are fine for older bikes
Regards
Wayne
Hi
I've bought one 3 weeks ago hadn't been used for 5 years
Recommission it ,good parts supply some rev3 parts fit, just a bit heavy at 80kg
Remember Dougie lampkin rode one
Happy trials
Wayne
Hi
Thanks for the advice but when I kicked it over last night there seems to be loads running out where the rear box meets and it smells really strong of petrol.
Could it be the float in the carb
Should I just keep running it until it gets red hot.
Regards
Wayne
Hi all
I've just bought a 1996 beta techno it had not run for 5 years the seller fuel it cannot it running.
Due to having seized brakes which have rebuilt. Its time to start the bike.
I've replaced the air filter and spark plug
The bike kicked over second time but a oily black fuel mix as come out of the exhaust it seems to be a fair amount
As anyone any ideas what this can be and how to resolve it
Regards
Wayne
Hi all
I bought a 1996 250 and need some advice on removing the rear master cylinder as it as seized
I've removed the two bolts but can't move it to get to it do I need to remove the air box
Regards
W
Hi
Haven't any idea on tyres but just ordered a front and rear mitts trials tyre for just under £100 I am returning to trials and as long as they have knobs on they will do.
The amount of use they will have it's a good chance that they will perish first
Regards
Wayne
Hi all
Just got a 1996 techno and i am in need of some advice so here goes.
Best oil for gearbox
Oil fuel mix ratio
Fork oil
Looking forward to your replies
Wayne
Hi all
Just returning to trials and was wondering where to buy a budget front tyre .
I am only going to have a play and not taking it seriously.
Regards
Wayne
Hi there
Jim of drayton the man to talk to.
Ive been bulding a bantam over the last few months and he as helped me.He also as helped me with my riding.
hope this is of sum help
wayne