scorpa250

Cheers Chris will give them a ring in the morning,that sounds cheap for a cover are you sure ?? Regards Scorpa250

Any Ideas is this a bad case or not to bad ?? how much is a new case ? Scorpa250

Hello all, changed the oil on my sons 125 rev3 and noticed the oil was more like milk ! done a trial today and again the oil is like milk,i checked the water and it has used a little . I take it a seal has has gone somewhere any tips before i pull it a part??? Cheers Paul .

Dont worry chaps have found a old post with the same problem, the is a good diagram of what to do from Martin swm Matthews . Cheers Paul

Hi All, can anybody help i went to change the oil on my 320 and i took the bolt out that is the kickstop gear stop ,i have the clutch cover off and the clutch basket but a cant see how to pre load the kickstart gear/spring? . Cheers Paul . 07989 313652

Are they riding modern or twinshock bikes????????

hi what you have there ia a montesa 123 rolling chassis (i think) witha yamaha dt175 engine (or dt125) .Regards Paul

Hi I had a nightmare with my sons rear brake same as you it over heated and i thought i would give it a complete rebuild seal kit in master cylinder seal kit in caliper.... all to avail.... to cut a long story short (about 3wks of swearing at it) i asked a yamaha factory mechanic and with all the information i told him he told me to get a new complete master cylinder and use a car vacuum bleeder system and it worked !!!! hope this is will help you .Paul

Have a look on the bath classic mcc website there is a practice area in Trowbridge Wiltshire Regards Paul.

Hi Just got myself a 242 and the forks need re-chroming where and how much ?? Does a mk 2 tank fit a mk1 as the tank on mine does look rather Big ? love the bike has'nt ran for a number of years but with a clean carb and some fresh fuel she fired up sounded good no rattles and the clutch is light .The gear leaver has a lot of movement from first to neutral is this normal? all the gears work fine. Lots of questions but its better to post a question as there is always someone with a answer than scratching your head for hours. Cheers Scorpa250

Thats a trick looking KT!!!!!!!!!! whats the spec and have you got another image of the other side Cheers Scorpa250

Cheers for that B40RT will strip the forks down and have a look . Regards Scorpa250 :

Marzocchi ,they look fine but Bang when topping out . Regards Scorpa250

Hello all, Just picked up a Nice Swm 320TL .Rode it in a trial today and was well impressed.After owning Honda tlr,s Fantic,s Majesty,s The Swm is a very under rated bike, it steers well goes well and looks good and boy it grips!!!!! The only gripe i have is the forks top out ,is there a fix for this ?? Heavy clutch,but after talking to Martin At Swm moto careful adjustment and a domino lever its not that bad .Roll on the next trial !! Scorpa250

Looking good Sooty!! will have to pop round and see it in the flesh,I picked up a Swm 320tl last week rode it in a trial today ....what a bike!! it has so much grip. Have you got a good tank/seat unit ?? is there anythink that you need ?? Cheers Budgie.

I think Craig at yamaha majesty.com has some Regards Paul

What's left to do Sooty?? had it running yet?? Regards Budgie.

Hi Sam i to have a tlm mine is a 220 can you post a picture of your tank ? cheers Paul

Hi All, just stripped my bultaco M92 down ready for a full refurb,did'nt find any nasty's all came apart very easy,the only problem is the tank and seat unit it is in poor shape leaking and the sides are damaged. Is there anybody doing copy's ?? Regards Paul

Thanks for that Bultaco49 The bike does go but it going to get a full strip and refurb its all there and runs a treat, had a full engine rebuild in 2001 and has'nt been used since not bad for a

Just picked up a bultaco,on the log book it says its a 325cc 1973 the frame no is B92016** the engine no is M92017** its got a all in one tank/seat unit in red which makes it what model ??? thanks .

Hey Sooty taking your time!!! have you got the engine sorted?? Regards Budgie.

From memory the first Majesty's had modified standard frames then went over to all new frame . Paul .

Has anybody out there done the flywheel mod on the 175 as on the birkett website ?? does it make a difference ? i have just got a ttr125 flywheel of e-bay and was going to put that one on a diet,any problems with doing this mod ?? Cheers Paul.

Hey Ducman.... what clutch casing is that off of ?looks very neat. scorpa250