postmanpat

I don't know if i've dreamt it....but is there a landrover bush that fits the TY? swing arm??

I've been told the barrel,head,gudgeon pin bushes and spacer are original shirty,i put a new piston and rings etc in,which are dt250mx,the piston needed 5mm taking off the skirt,and the headgasket needed tweeking.I aim to start it sometime soon..............when i get over the first kick nerves!

I've just completed a 200 conversion on a TY175,anyone out there got sugestions on carb size so i can get the most out of the bike,also dimentions for swing arm lengthening and shock reposition.Cheers.Chris

Hey anyone out there got info on how to convert a 175 to 200? i've been told there could be a couple of ways? I've access to a machine shop,just need to know the best way and what parts to use.Cheers.Pat

Try Yambits in Boroughbridge,they also deal on evilbay

Ordered one today from tytrials

Got the beastie up and running,fork seals done,oil pump disconnected,got an issue with the clutch though,there is too much play at the lever,i've adjusted as per manual but it's still sloppy.....any advice?

Hey,got mine from trialsbits,about

Hi there,i've just bought my first TY,it's a 125 and i want to know lots of stuff about them...... mix ratio,tyre pressures and any "normal" problems mods etc.Ta.

Anyone in the York area seen th front page of The Press......York police have recovered what seems to be an '04 315 Mont,white plastics,blue forks....any help to anybody??

Halfords would love having a proper bike in for once ! i've used the paint on a mont and my helmet..not a bad match,cos its quite bright

Have a look at Humbrol gloss red model enamel paint..might be a near match?

Hey,which is the best way to soften an 04 pro? a head spacer,or 2 bottom gaskets? Cheers.

I used a 12mm rawlbolt and slide hammer to pull mine out

Take a look at ASA140 chain,you wouldn't get a dnf!

You can get 60ml syringes from a vets,cost about

2 secs,got it apart this afternoon,bit of scoring,but not too bad.....gonna put it back together after a clean up,see what happens........watch this space,cheers lads for your help.

Hi,it's locked up solid!!!,you could stand on the kickstart!

Hi,been out on the bike today,'04 250 Pro,it wouldn't rev properly so whipped the carb off and gave it a good blow through,put it back together,kicked it over......the bike fired and revved a bit.......then stopped suddenly,now you can't get the motor to turn over,it's solid,any ideas? Cheers.Chris

Hi,how many times have you changed the oil? could be water still in the crank case?

There's some plastic guards on eBay at the mo.

Hi,if it's the kickstart gear they're

Tsubaki used to be the mutts nuts in the engineering field,i sold thousands of metres of it,i didn't know they did bike stuff though,where did you source it?

Grey smoke could be water getting in to the cylinder,poss head gasket?,that would give you a lumpy running.

Hi,i had one as my first bike...stick a slow throttle sleeve on,and have a real good time.