| |
-
Cheers lads,i did mean water/antifreeze,i'm a bit fried at the mo,being a postie at xmas is fun!!!!!!!!!!!!!!,then my bike breaks.....just made my brain give up.I didn't know about the pump trick,so i dropped the antifreeze.....ah well.Bits coming thursday,i'll let you know how it goes.
-
Aye up lads,whipped the casing off this afternoon,the gear has sheared at the base,lucky me.....no other debris,just ordered the new bits plus a gasket,what coolant should i put back in?
-
Help!!!!!!!!!!!!! I've a 250 Pro '04,out riding today and 1/2 way through 3rd lap the kick start stopped turning the motor over,the lever still has return spring tension,but just spins the shaft
-
I thought the same,the mont type doen't have a pinch bolt at the back
-
-
Hi,i'm new to Gasgas,i've an'04 250 Pro......looking at the wiring diagram,there seems to be a switch to change the ignition curve,my bike hasn't one,is it supposed to?
-
Hi,just sold my 315,def got a plastic tank,the factory graphics are laquered in,but you can paint them or graphic how you want,the mudguards are a different matter though,you have to specify vinyl suitable for use on polypropelene otherwise it won't stick,i used a guy that did work on MX bikes
-
Hi,i've just bought an '04 250 Pro,can anyone tell me the factory settings for front and rear suspension,i want to start from scratch,as i've never had a Gasser before.Cheers
-
I run mine 3-4 turns out from right in
-
Hi,my in-law had a TXT250 that had a similar fault,there was a fine crack in the rubber connection on the reed block to carb,just run a fine bead of superglue into the crack......his problem went
-
Any chance you've cooked the fluid? has the brake been dragging?
-
-
The ref for an open cage type starts K........
-
Go for it,it's a doddle,2 socket caps to undo,then tap n unwrap
-
Only saw a couple at the Dirtbike show,they look crap,better off with a Xispa,ps why wasn't there a Beta stand?
-
Hi,just done the swing arm and linkage bearings on my 315,pm me i've the bearing refs and oilseal sizes and refs
-
Hi,mine is an AJP on an'03 315
-
Don't knock it saw it yesterday at a trial,there were more crap sounding betas than the xispa
-
Aye up the guy said it was a proto,looked nice,apart from the weld etc,we'll have to wait till next month to see the end quality.
-
Haven had one at an Eboracum trial today,didn't look too bad,until you looked closely,pinholes in the dull ali swing arm,ropey welds.The guy said it was a proto,and that 125,250 and 280 will be in stock next month
-
Hi,anyone out there know the ref for a 315r '03 steering bearings?
-
Hi,i got some mx adaptors off evilbay,
-
Hi,i made a new inner tube from perforated steel,just formed it round a brush shaft,and wired it together.got the sheet from a diy shop,about 2' square for
-
Hi,i've gone IRC,they seem to work well here in"sunny" N.Yorks
-
Hi,thanks for all your suggestions,finally sorted the tank!!!!!!!!!!,used PERMABOND,FLEXON F246,a toughened acrylic adhesive.
|
|
