Vertigo
215 topics in this forum
-
Fan was on constantly on last ride out.Coolant checked.Attached my GET WiFi reader and it showed nothing.Except fan control was blocked out?Temperature sensor read open circuit for resistance between ground and terminal with wire disconnected?Seemed to be cutting in and out tonight when testing?Anyone seen this before of any ideas?
-
- 2 replies
- 2.2k views
-
-
Hello. I'm the only vertigo in South Korea. It doesn't start, so ask a question Unplug the magnetic kill switch to wake up the ecu When the map led blinks constantly, I kickstar. Then the map led will blink very fast and the start will not start I want to know why 9v battery replaced with new one The plug was also replaced with a new one. I used Google Translator
-
-
- 7 replies
- 5.4k views
-
-
Hi. The Vertigo user lives in South Korea. This time, I'm trying to buy a 9v high battery, so I don't have much in South Korea. It takes a long time to purchase from Ali Express. So I made a 9v replacement battery with aaa rechargeable batter. the charge is good, up to 9vIf
-
- 1 reply
- 2.7k views
-
-
hi.... I'm jeong won living in South Korea. Vertigo 12v start battery connection is inconvenient So I made a 12v portable starter battery with 18650 batteries. It is 11.1v by connecting three 3.7v batteries, but 12v comes out because it is 4 volts when fully charged. In the photo, the battery hold is on the side but is actually under the air filter. Make a switch and start the engine When started, disconnect the switch. If the switch is connected and kickstarter 3 starts.
-
-
- 4 replies
- 4.7k views
-
-
Bonjour. If this is possible, could you give me a copy of the manual for the Vertigo 250 from 2020. I have some concerns. Thank you. Great site
-
-
- 3 replies
- 1.3k views
-
-
Got a 2021 Combat works 250, and its really hard to start from cold. Once its hot, not problem, 1 or 2 kicks every time. I've read that i should be doing 3/4 slow kicks, then quarter throttle and kick it properley. I'm usually into about 20 kicks before it comes alive? It's got a brand new BPMR4A plug in (previously a 6 but same symptoms). Fuel is super unleaded with 30ml (170:1) of rock oil. Any ideas?
-
-
- 10 replies
- 3.3k views
-
-
Hi everyone, I've pulled the gear cassette to replace the kick start gears. That's all sorted but I noticed the shift sensor magnet is free to spin on the shift drum. Surely this can't be right? Any help is greatly appreciated. If anyone has a workshop manual it would be ver helpful!
-
- 0 replies
- 1.3k views
-
-
Is the Vertigo Vertical Combat 250 too much bike for a beginner trials rider? Novice dirt bike rider, 185 lbs.
-
-
- 5 replies
- 2.4k views
-
-
2016 300, with the updated 2018? "battery less" ignition, starts and runs 1st kick when adding a 12 volt source, no spark, no fuel pump without 12 volts added, when running at 1800-2000 rpm its charging at 14.4 volts, just seems to not be creating enough electricity for starting requirements.. Help!
-
- 1 reply
- 1.6k views
-
-
I have a 2019 Vertigo Vertical 300 and I would like to try the 2020 Vertical 300 map. It would be great to compile a database of maps that the Vertigo owners can share and try. This forum allows the upload of the map file format. I found a good instruction video that is posted below. The WiGet app for the GET Ecu makes it very easy to share maps. I currently have these maps to share: 2020 R2 300 2019 Vertical 300 I will update the list and post the maps here as I get more Thanks, DT
-
-
- 24 replies
- 10.3k views
-
-
Hello, Not exactly a major issue, but I noticed that my recently purchased R3's headlight is not on. There is a red button behind the headlight, is this a switch for the headlight? I assume as soon as the bike starts the light should come on? Thanks, Nick.
-
- 3 replies
- 2k views
-
-
Out for a ride This morning and my 2017 300 combat started blubing and running like a bike running low/out of fuel (it had a full tank). It cleared for a bit and then as soon as I started opening the throttle it would bog, but would tick over fine. I stopped the bike and then it wouldn't restart. After a long push back to the van I changed the plug (Had a good spark) and swapped battery, but It still wont start. I can hear the fuel pump cycle when I set the start button. So I'm thinking Injector blocked or a fuel pressure issue. Has anyone else had something similar? Any practical advice?
-
-
- 12 replies
- 9k views
-
-
Hi everyone, just took my recently acquired 2016 ice hell out for a ride the other day. it was running fine for about 3 hours and then about an hour after i refuelled it, it sounded like it was running out of fuel and then died. after about 4/5 kicks it would start again and then run for 5 minutes until it would do the same thing anyone have any idea what it could be? I've heard possible fuel regulator? but not too sure cheers Andy
-
-
- 14 replies
- 6.7k views
-
-
-
Hiya, anyone tried the e10 unleaded in their vertigo in the Uk, good or bad opinion? does it make any difference over E5 given it’s got 2stroke mixed in? though I would ask before I tried it, been using super unleaded e5 until now, but it getting harder to find. cheers
-
-
- 9 replies
- 4.4k views
-
-
hi fancying going back to 2t from a 300rr montesa and have been looking at the vertigo but iv spoke to a few people who have said steer clear they are too unpredictable nice to ride but they've had loads of problems with theres any advice before i buy would be helpful thanks
-
-
- 24 replies
- 19.1k views
-
-
Hello all, has anyone bought and experimented with the Athena Wificom for 2018/2019 Vertigo? I was thinking about buying the device, as my 2019 Vertical 300 keeps running rich even on dry map, the spark plug gets sooty and overall the bike feels like it's running too rich at high revs (four stroking). Air filter is always clean, tried different new spark plugs, fuel is 100 octane, fresh, 0,5% Motul 800 oil. Dealer says bike is ok, which is 99,5% true, but I was thinking about turning the "carburation " leaner with the Wificom device. Any experience/advice? Thanks in advance!
-
-
- 16 replies
- 10.3k views
-
-
hi all looking for a clutch basket tool near leeds west yorks without paying vertigo uk postage happy to rent or other such arrangements
-
- 0 replies
- 1.6k views
-
-
Any idea of how change rear brake fluid whitout remove mid bike?
-
- 0 replies
- 1.5k views
-
-
Hi, I need to pull the clutch basket on my 2017 300. Any one know the correct thread pitch of the puller? I will have to make one or find a different one than I can order online. Thanks, Dave
-
- 0 replies
- 1.6k views
-