Vertigo
216 topics in this forum
-
Is the Vertigo Vertical Combat 250 too much bike for a beginner trials rider? Novice dirt bike rider, 185 lbs.
-
-
- 5 replies
- 2.4k views
-
-
2016 300, with the updated 2018? "battery less" ignition, starts and runs 1st kick when adding a 12 volt source, no spark, no fuel pump without 12 volts added, when running at 1800-2000 rpm its charging at 14.4 volts, just seems to not be creating enough electricity for starting requirements.. Help!
-
- 1 reply
- 1.6k views
-
-
I've just been cleaning my nitro's battery compartment and pressed the test button on the battery and theres no lights on... With never owning one before I would imagine that the battery should hold some charge? and any ideas or how to diagnose what the problem is? Anyone got any experience in this as there's absolutely diddly about it in the manual or online about it Thanks in advance Mick
-
- 5 replies
- 4.4k views
- 1 follower
-
-
-
hi all looking for a clutch basket tool near leeds west yorks without paying vertigo uk postage happy to rent or other such arrangements
-
- 0 replies
- 1.6k views
-
-
Hello, Not exactly a major issue, but I noticed that my recently purchased R3's headlight is not on. There is a red button behind the headlight, is this a switch for the headlight? I assume as soon as the bike starts the light should come on? Thanks, Nick.
-
- 3 replies
- 2k views
-
-
Any idea of how change rear brake fluid whitout remove mid bike?
-
- 0 replies
- 1.5k views
-
-
Hi, I need to pull the clutch basket on my 2017 300. Any one know the correct thread pitch of the puller? I will have to make one or find a different one than I can order online. Thanks, Dave
-
- 0 replies
- 1.6k views
-
-
Hi, the clutch on my vertigo combat is very firm/stiff so makes it difficult to use clutch control. Someone mentioned the springs need to be reduced in size, or lube the cable ? Any ideas on please ?
-
- 4 replies
- 3k views
-
-
I have a 2022 Vertigo Nitro Jaime Busto Replica 300 that runs very rough past 1/4 throttle. First 1/4 is pretty good, idle is fine. Did it pretty much from new, bike now has 30 hours on it, and it seems to be getting worse. Past 1/4 throttle it runs very rough, repeated surging and near stalling, but only under light load. Hard acceleration is good, steep uphill is good, 5th gear on flats or slightly downhill is terrible, to the point where it nearly stalls. There's also a spot about 5000 RPM where it just doesn't run cleanly at all, lots of smoke and very rough. This bike has the lithium battery with a different wiring harness from earlier models and a 6 p…
-
-
- 10 replies
- 7k views
-
-
Hi all new to this group hopefully someone can figure it out? right I have a vertical r 2019 250 the bike will start and tick over soon as throttle applied bogs out, fitted new tps sensor and recalibrated with Wi-Fi.com still getting the same symptoms I’m 99% sure it’s the tps sensor I have tested the fuel pressure and is all correct! I’m falling out of love with it after spending a arm and a leg troubleshooting the problem? Initially the problem seem to occur after a trip to COWM where the bike was upside down running for no more than 5seconds bike ran all day with the problem occurring as I was going back to the van any help appreciated
-
- 1 reply
- 2.4k views
-
-
After doing a ride at altitude this past weekend, now back at normal riding level I am finding my bike will just stall if sitting at idle. My partner's bike is doing the same. it's like I now always need to have a little bit of throttle on to keep the bike from dying. It also seems a little less powerful at the lower revs but that could just be my imagination. Bikes are 21 R3 and 22 JBR
-
- 0 replies
- 1.4k views
-
-
Hi guys, Does anyone have a problem with an oil leak in the clutch housing? I tried to add a sealed gasket (nural 60) but it lost oil again. Oil doesn't leak immediatly, it's a next day when I see a spoot in the floor. By other hand, I sense that my clutch drags a bit when I have a gear engaged. I will try to change the position of clutch's plate to the number 2, it's recommended?
-
- 1 reply
- 2.7k views
-
-
Hello I just bought a vertigo combat 125 built in 2020 for my son. I am looking for a workshop manual, I have not found anything on the internet, can someone help me?
-
- 1 reply
- 2.9k views
-
-
Does anyone have a manual on the Dl replica 2021 please 🤞🏻
-
-
- 2 replies
- 2.9k views
-
-
Hi just fitting a low comp head insert, anyone know the head bolt torque settings please
-
- 0 replies
- 3k views
-
-
I’ve had my 2017 bike from new and never had any problems - still on the original 9V battery! However, when I got the bike out yesterday for the first ride in a few weeks it would start OK but would not run smoothly. It felt as if it was running very rich, it wouldn’t rev very cleanly and then struggled to tick over. I checked the plug and it was very black. Also quote smoky when it was running. Vertgio UK weren’t sure what it was but clarified that the TPS sensor failure usually makes the bike very lean, so unlikely to be that. Am about to book it into a dealer for a check, but has anybody got any suggestions?
-
- 11 replies
- 3.4k views
-
-
When I’m out on my 2020 DL, 300, my wife tells me I stink of fuel. Why🧐
-
-
- 5 replies
- 2.1k views
-
-
Hiya, anyone tried the e10 unleaded in their vertigo in the Uk, good or bad opinion? does it make any difference over E5 given it’s got 2stroke mixed in? though I would ask before I tried it, been using super unleaded e5 until now, but it getting harder to find. cheers
-
-
- 9 replies
- 4.4k views
-
-
Hi Everyone, 2019 Vertical R and the in-tank fuel filter was a bit dirty (to say the least) Any recommendations for cleaning the injector? Will it be a problem? Does anyone use any additives successfully? Cheers
-
- 1 reply
- 1.9k views
-