Everything posted by trapezeartist
-
Where Has My Friction Gone?
Never used it before that first time mentioned in my original post. But it's not something I want to do before every trial. Anyway, last trial I used an old set of pads and didn't use the brake cleaner. That worked. For the future I shall continue to scuff the pads with abrasive, but wipe them off with dry paper and put them straight in. I'll still use brake cleaner on the discs because I use a lot of WD40 for cleaning, but I'll abrade them afterwards, not before. Hopefully that should see the job OK.
-
Where Has My Friction Gone?
Yes, every trial. It's something I've done ever since I raced cars and karts as they were very prone to glazing when burbling back to the paddock with hot brakes. I've continued the procedure with the trials bike because I always find a film of dried mud on the face of the pads. It's interesting that you would point your finger at the brake cleaner. The can is nearly empty so it has been used successfully quite a few times and the problem has only appeared at the last two trials. I've just re-prepped the bike and put the old pads back in so I'll see what they are like. Before the weekend I'll also have a sneaky ride down the road to check the brake beforehand.
-
Beta Factory 250 Flywheel Weight
When I had my Beta 250 (UK spec) I was tempted to do the opposite, just to find out the answer to your question. I never did though. The issue I did find with the heavy flywheel was that on up-changes the bike slowed down faster than the engine so gear changes were clunky and unsynchronised. Obviously it didn't affect trials performance but I did find it ugly.
-
Basic info new rider
I agree with timdog. Just one small thing to add. On slow turns using the front brake is likely to cause it to slip away from you because it is at an extreme angle to the direction of drive and is already reluctant to roll. Except on an uphill turn I would use a bit of rear brake so that the motor has to work against it all the time. That way the only thing you need to control your speed is to modulate the throttle. Otherwise you may find yourself trying to flip between a touch of throttle, then a touch of brake, and that's much more difficult.
-
Where Has My Friction Gone?
I've recently found a problem with lack of braking power on the front of my Electric Motion. First, a little bit of background: I've had the bike for three years and this problem has just started. The front brake is a braktec monobloc. My normal procedure between trials is to abrade both pads and disc with wet'n'dry and clean with brake cleaner. Three trials ago I fitted new Galfer red pads. For the first trial they worked fine. At both of the next two I found that the braking power was very weak. Although it was something I had never done before, and was a bit sceptical about, I rode up and down a bit with the front brake on to heat it up, then sprayed it with water. It was hot enough to hiss and generate quite a lot of steam. Thankfully this procedure seemed to get the brake working adequately but it's going to be a bit of a pain if I have to do that every trial. Does anyone have any thoughts? Just to confirm, the hydraulics have not been disturbed and the lever feels just as firm as ever. If I don't find any other solution I think I will put back the old pads for the next trial and see if they are any better.
-
Throttle control when wheelie
No-one! 🤣
-
2023 Domino throttle upgrade?
I've forgotten how the response compares; it was a very fine difference. I just like the Domino for it's quality feel and stronger return spring. As you say free play is OK, I assume you bought direct from an EM dealer. I bought mine (much cheaper) from a different source. Moving the pot 1 tooth wasn't enough and 2 teeth was too much I ended up going 2 teeth and trimming a bit off the closed-stop to get it right. Quite a lot of work but it's lovely now.
-
Vegan friendly trials boots
Meat is plant-based too. Cows eat grass. 😇
-
Hey up
You can readily ride a twin shock in a normal trial, and generally you can also ride a modern bike in a classic trial (though many clubs have a minimum age for the rider). If you're starting off on the easy route, you'll find it's the same severity on both types of trial. I think you need to be an old-bike fan to have a twin-shock or pre-65. Otherwise you just find yourself wishing for something better/newer/more modern. I had a twin-shock for a short while because it seemed the sensible thing to do as I was riding mainly classic club's trials. I quickly changed back to a modern.
-
NATC Moto trials round 1&2 Kingman AZ April 13 & 14
I think they rode the tie-decider section three times. I'm not sure of specific scores but Toby won. Quite an achievement without his regular minder and (presumably) his own bike.
-
Vegan friendly trials boots
I've no idea. I bought them six years ago because they were the only trials boot that claimed to be waterproof, which seems to me to be a fundamental requirement for trials. Sorry no parlo Italiano.
-
2024 Mecatecno Dragonfly
On my EM, I have dielectric grease around all the connectors that run along the top of the frame. And I've used silicone on the cover where the main power cables go into the motor. The only water problem I've had was when the primary drive breather sucked in a bit of water (and that was my fault for routing the breather too low).
-
Vegan friendly trials boots
My Gaernes are vegan-friendly. They've never once kicked a vegan. 😀
-
2024 Mecatecno Dragonfly
Regarding dubious behaviour in slippery conditions, the owners say the grip is fabulous. There's something about electric, because the EM grips well too.
-
Clutch Breather
I can't get to the bike at the moment to take a photo, but the breather comes out of the clutch/primary drive cars on the right hand side just behind the motor. Peer in past the rear brake m/cyl and over the main power cables into the motor and you'll find it there. It should have a black plastic tube attached, which is long enough to lead up to somewhere near the top of the rear shock. If you have any doubt over the clutch or it's oil, lay the bike on its side and take off the cover to have a look. It's a five minute job.
-
2024 Mecatecno Dragonfly
The Mecatecno is an amazing bike. Unfortunately at the moment I can't justify the upgrade cost from my present EM, but I would almost certainly go for it if I could. "Almost" because I would also test a '24 EM before making the final decision. Yes, Mecatecno definitely needs a sub-forum on here as I posted about a year ago, but nothing has happened yet. Xispa has it's own sub-forum and I've never even seen one!
-
Still selling
It seems I'm wrong. Apparently there is a new UK importer, though the prices are nowhere what they were. Much closer to the established manufacturers.
-
SSDT Newbie
Have a look on YouTube. There's a chap from Northern Ireland did a series of about 6 videos on preparation for the SSDT. I don't think it will answer your specific question but you will certainly gain something from it. Also look at the bike preparation advice on the Beta UK website. Even if you're not riding a Beta you'll find a lot of the information applies to any bike.
-
Newbie Herefordshire
Gwent Classic have a trial in a couple of weeks, not too far from you.
-
JAIME BUSTO NEWS
He last visited the forum 11 months ago, and last posted something over 3 years ago. It seems like he has lost interest. At least it's good that the website is still here, but perhaps it's time to hand over to someone else.
-
I see why !
Re the numbers, it helps a lot if clubs provide a second number to go on the back of the helmet. The last few times I've observed I've used the Trial Observer app. Assuming I have a decent view of the front of the bike as it enters the section I tap it in immediately so I don't have to carry the number in my head.
-
I see why !
Good solution, at a price! If you think you might get 100 riders, you'll probably need about 200 bibs so you can overlap the numbers and cover varying entries on each route. If the bibs are a fiver each, that's £1000!
-
Map Indicator Light
This post had sunk so I forgot it and didn't update. I also have used a '22 command switch which I mounted upside-down. That puts the FRB button in a better place for my thumb, and I can live with the word 'map' being upside-down. I believe '23 switches are reversed from '22. I've also just fitted a Domino throttle. I advances the potentiometer 2 teeth to remove the dead motion but it is a little bit too tight now, so getting it spot-on is still a work in progress.
-
Toby beats Bou
It's way bigger than a big deal. Who else has managed it in the last few years? Adam Raga, not for a while I think. Jaime Busto, once or twice. No-one else as far as I know.
-
ACU licence
I solved my licence/wallet problem. Last years licence was an ‘expired pass’ so was hidden. This years licence overwrote it when I clicked ‘Add’ but it stayed hidden. Once I undid it all was well.