Vertigo
215 topics in this forum
-
Was wondering does anyone know how much oil per fork and what weight ?
-
-
- 1 reply
- 2.1k views
-
-
Hi guys, Does anyone have a problem with an oil leak in the clutch housing? I tried to add a sealed gasket (nural 60) but it lost oil again. Oil doesn't leak immediatly, it's a next day when I see a spoot in the floor. By other hand, I sense that my clutch drags a bit when I have a gear engaged. I will try to change the position of clutch's plate to the number 2, it's recommended?
-
- 1 reply
- 2.7k views
-
-
Hi what are the vertigo bikes like to ride and reliability I’m not after one at the min just curious as never seen one in the flesh
-
-
- 1 reply
- 2.2k views
-
-
I want to exchange the stock spring of the rear shock against a stiffer one. After looking into the spare parts book and reviewing the assembly directly at the bike, the plan would be: - Loosen both screws DIN 912 M10x80 holding the dog bones - Remove the rear screw of them completely and swivel the dog bones in order to be able to loose and remove the screw DIN 7984 M10x40 that fixes the lower end of the rear shock - Remove the upper screw and the rear shock Does this make sense or do other parts need to be disassembled first in the area of the lower end of the rear shock? Thanks, Canario.
-
- 1 reply
- 2.3k views
-
-
Hi, this is Ryder living in South Korea. During maintenance, I found out that the rear swing arm fixing bolt was cut off. So I want to know if I can separate the side frames. Thank you in advance. It's translated into a translator application, so I understand if there's a wrong sentence.
-
- 1 reply
- 1.9k views
-
-
Hi all new to this group hopefully someone can figure it out? right I have a vertical r 2019 250 the bike will start and tick over soon as throttle applied bogs out, fitted new tps sensor and recalibrated with Wi-Fi.com still getting the same symptoms I’m 99% sure it’s the tps sensor I have tested the fuel pressure and is all correct! I’m falling out of love with it after spending a arm and a leg troubleshooting the problem? Initially the problem seem to occur after a trip to COWM where the bike was upside down running for no more than 5seconds bike ran all day with the problem occurring as I was going back to the van any help appreciated
-
- 1 reply
- 2.4k views
-
-
Hi. The Vertigo user lives in South Korea. This time, I'm trying to buy a 9v high battery, so I don't have much in South Korea. It takes a long time to purchase from Ali Express. So I made a 9v replacement battery with aaa rechargeable batter. the charge is good, up to 9vIf
-
- 1 reply
- 2.7k views
-
-
And it's Dabill in third!!!!!!
-
- 1 reply
- 2.5k views
-
-
Hi Everyone, 2019 Vertical R and the in-tank fuel filter was a bit dirty (to say the least) Any recommendations for cleaning the injector? Will it be a problem? Does anyone use any additives successfully? Cheers
-
- 1 reply
- 1.9k views
-
-
Hello everyone, I have a problem again with my Vertigo Busto 2021 250cc and I can't find the solution. I would like to post the problem to see if you have a solution. Some time ago, I had fueling problems during training. Thinking that dirt had gotten into the air screw of the injection body, I dismantled the injection body. I noticed that the tps sensor was free with the screw loosened.. Since then, it's been a mess! The motorcycle starts cold but rattles and smokes abnormally then when hot it stops by itself. Here's what I did: TPS Replacement TPS re…
-
- 1 reply
- 2.9k views
-
-
Hello, could you tell me what could be the problem with starting a cold engine? I have to put the bike on a stand and kick it as hard as I can about 20 times. After starting, the bike starts right after turning off the engine, but if it sits for 2 minutes, it is very difficult to start again, sometimes even impossible. The bike has a lot of mileage (about 1000 engine hours). After purchasing it from the previous owner, I replaced the fuel filter, fuel pump, injector, hose clamps in the gas tank, ignition coil and condenser in an attempt to find the problem. After that, everything got better, but the problem remains. Direct fuel injection into the intake manifold helps; in…
-
- 0 replies
- 1k views
- 1 follower
-
-
Hello, Has anyone upgraded their exhaust pipe to Titanium and wish to sell the stock unit. mine is quite dented and I would consider a used one before trying to "un-dent" it Cheers Ed
-
- 0 replies
- 1.7k views
-
-
Hi guys , just replacing the kickstart assembly on my vertigo vertical, and can't get the kickstart to return, do I need to take the clutch off for re assembly, did it about 2 yrs ago but can't remember what I did
-
- 0 replies
- 1.7k views
-
-
Hi, I need to pull the clutch basket on my 2017 300. Any one know the correct thread pitch of the puller? I will have to make one or find a different one than I can order online. Thanks, Dave
-
- 0 replies
- 1.6k views
-
-
Is there a service manual online for the Vertigo bikes? I've only found the sparse owners manuals and the parts books.
-
- 0 replies
- 1.9k views
-
-
Hy, maybe anybody has the same problem. My Vertigo R3 MY 2021 starts poorly when hot. When the fan was running and the engine was off longer than about 15sec. it fires up very poorly. The problem was the capacitor and the cables which look like this: hope this helps anyone BR M
-
- 0 replies
- 2.3k views
-
-
Hello, i´m searching for a wiring diagramm for my Vertigo R3 300ccm year 2021. Has anybody a idea where i could get this please? I hope someone can help me. thanks for information and br
-
- 0 replies
- 1.5k views
-
-
Hi I’ve just bought a 2016 combat 300 that won’t currently start (bought with an intermittent starting issue). What does the powerbox part number V-0533 do within the ignition system? thanks
-
- 0 replies
- 1k views
- 1 follower
-
-
Hi guys I’ve recently had a 2017 ice hell, I was just wondering what the sag is like on your bike guys? bike on paddock stand rear wheel off the deck I can lift the rear wheel a few inches but the motion feels very loose like a bolt has snapped or the sleeves in the linkage by rear shock have worn, anyone else noticed this?
-
- 0 replies
- 1.5k views
-
-
Any idea of how change rear brake fluid whitout remove mid bike?
-
- 0 replies
- 1.5k views
-