Aprilia

So after a top end rattle noise I stripped the top end there is play in the crank large bearing top end has no play... I can get the crank kit or also I can get a full brand new crank already built up ..price is a bit hefty any advice on who could rebuild my bottom end for me ? I can rebuild the engine myself no problems but not confident in rebuilding a crank any help or suggestions where to start thanks

Hi Guys, Really could use some suggestions here. I am based in New Zealand and as far as I can tell Aprilia never imported trials bikes here. So, no parts supplier. Can any one suggest a dealer or supplier I could use to get parts? Cheers Iain

Ive got the chance of aTX311M but don't know a lot about them. I was after a air cooled mono for our clubs pre 90 route and was after a Fantic but the Aprilia has been offered me. Can I get parts for the Rotax motor ok and are there any known problems with them as this bike has a issue with the kickstarter. Thanks

Hi all I have two Climber 240 (91 and 92) in Japan. I am in the middle of my change the front fork oil project. I have some questions. 1. Oil level measurement (mm?) from the top of fork edge? 2. How much does each fork needs the oil (Aprilia manufacturer’s recommended ) 3. Recommended degree of viscosity. (or fork oil model number・part number) I don’t have a service manual of Climber... regards, Teru

Hey, anyone know anything about setting the rotary valve timing on a 1993 Aprilia climber 280r , where is the timing mark ,degree ,etc anything would be awesome. Thanks

Have a look at the early Aprilia towards the end, Hiro engine ? Also a good selection of SWM's,Italjets etc.

I could use some help i have had my bike standing for a couple of months and the clutch has stopped working , i have stripped it down as far as i dare and all seems in order , put it all back and still no joy. the problem is i can pull the clutch lever in and it wont work( ie the engine is still driving the wheel ) ,the springs on the plate must be working because the lever springs right back . is it something simple i am missing ?

Hi All, does anyone have any idea what these are worth? are there any big issues with them? its a 92 , all there , all works as is should, needs a rear tyre (dont they all!) looks in better nick than a lot of 2002 bikes i have seen. any info at all cheers paul

im thinking of getting an aprilia climber for nostalger purposes any thorts are they any good ? anything to watch out for i used to ride trials in the 90s and fancy collecting the classic 90s model bikes

Hi all, I was out with the Climber a week ago and it ran fine for an hour but then when it was on tick over just stoped and didn´t start again. Back home I have been tracing the problem and have tried or rather changed the carb, plug, plug cap, kill switch, and the black box under the tank. I have now found out that when the plug is out and its turned over there is no spark the most of the time unless you turn the engine over a lot faster then the spark apears again. It´s not possible to kick it over this fast with the plug in and it just fires up very very ocaisionaly for a couple of beats now and again. I´m thinking that it´s in the stator plate…

Hi I am new to this, Last time I rode a trails bike was 1972, I found a nice old Aprilia 311 in good shape. Just a few questions to start, What fuel mix should I run in the bike? Is there anyplace in the Us that has any parts? I started it on a 50 to 1 mix seemed to run ritch, but everything seemed fine. There is also a engine compression adjustment device on the front of the engine, I have never seen one? Thanks for the help, Mark

Hello fellow climber owners, Have been doing one up over the last year or so (full strip down) and now fully built . It starts OK and runs OK so decided to take it out the other weekend (to relive my younger days as trials rider !). After about 30 mins one of the water pipes started leaking hot water (couldn't see where) and notest the fan wasn't working, so off to the van and home. Had a look the other day and tried putting a 6 volt battery over the fan and to my delight the fan spun up. So next was the fan switch and once it was removed tried to test it by seeing if it earthed out ie. single pin to body of switch, in boiling wate…

Hi, I'm looking for the air filter manifold for Aprilia TXR 312, I can't find anything for sale, do you know where to find it? It would also be useful to have a spare parts catalog or exploded views, do you know where to download it? Thanks

hi just bought 280 climber as first trial bike were can i get spares for it as i need new air filter is there a manual available and one last question how do you check gear box oil

does anyone know any websites or places were they sell parts and performance parts for minarelli am6 engines thanks

Just got Aprilia tx 320 in boxes. There is two engines worth would i be better to source complete engine because it would need every bearing replaced and no saying what else.

Hello, i bought this bike 4 months ago i have noticed that the forks are loosing oil, so i have to change the o rings and i want to know how much oil do i have to put in each one and which type of oil. thankyou

Any ID help with this Aprila Climber 240 # EO DGM 52584OM.

I am new to the group, and own a climber 240. I am having trouble with the install of the kickstart return spring assembly. Is there someone who can help me with this? I am not sure how the retaining bolt on the bottom of the motor holds anything? I assemble the clutch cover only to start the motor and have the kickstart gear click against the clutch gear once the return spring pushes its gear out against it...... is there a utube on the install? defeated......

Hi guys, I'm after some help on a aprilia climber 240 I purchased, I seem to be having problems starting it, I think I've manage to put it down to a spark problem, it doesn't seem to be sparking all the time, any suggestions, and does any one know the ohms readings for the stator/windings, any information would be much appreciated