postmanpat

Cheers lads,i did mean water/antifreeze,i'm a bit fried at the mo,being a postie at xmas is fun!!!!!!!!!!!!!!,then my bike breaks.....just made my brain give up.I didn't know about the pump trick,so i dropped the antifreeze.....ah well.Bits coming thursday,i'll let you know how it goes.

Aye up lads,whipped the casing off this afternoon,the gear has sheared at the base,lucky me.....no other debris,just ordered the new bits plus a gasket,what coolant should i put back in?

Help!!!!!!!!!!!!! I've a 250 Pro '04,out riding today and 1/2 way through 3rd lap the kick start stopped turning the motor over,the lever still has return spring tension,but just spins the shaft

I thought the same,the mont type doen't have a pinch bolt at the back

Cheers lads.

Hi,i'm new to Gasgas,i've an'04 250 Pro......looking at the wiring diagram,there seems to be a switch to change the ignition curve,my bike hasn't one,is it supposed to?

Hi,just sold my 315,def got a plastic tank,the factory graphics are laquered in,but you can paint them or graphic how you want,the mudguards are a different matter though,you have to specify vinyl suitable for use on polypropelene otherwise it won't stick,i used a guy that did work on MX bikes

Hi,i've just bought an '04 250 Pro,can anyone tell me the factory settings for front and rear suspension,i want to start from scratch,as i've never had a Gasser before.Cheers

I run mine 3-4 turns out from right in

Hi,my in-law had a TXT250 that had a similar fault,there was a fine crack in the rubber connection on the reed block to carb,just run a fine bead of superglue into the crack......his problem went

Any chance you've cooked the fluid? has the brake been dragging?

So has my 315,cost me

The ref for an open cage type starts K........

Go for it,it's a doddle,2 socket caps to undo,then tap n unwrap

Only saw a couple at the Dirtbike show,they look crap,better off with a Xispa,ps why wasn't there a Beta stand?

Hi,just done the swing arm and linkage bearings on my 315,pm me i've the bearing refs and oilseal sizes and refs

Hi,mine is an AJP on an'03 315

Don't knock it saw it yesterday at a trial,there were more crap sounding betas than the xispa

Aye up the guy said it was a proto,looked nice,apart from the weld etc,we'll have to wait till next month to see the end quality.

Haven had one at an Eboracum trial today,didn't look too bad,until you looked closely,pinholes in the dull ali swing arm,ropey welds.The guy said it was a proto,and that 125,250 and 280 will be in stock next month

Hi,anyone out there know the ref for a 315r '03 steering bearings?

Hi,i got some mx adaptors off evilbay,

Hi,i made a new inner tube from perforated steel,just formed it round a brush shaft,and wired it together.got the sheet from a diy shop,about 2' square for

Hi,i've gone IRC,they seem to work well here in"sunny" N.Yorks

Hi,thanks for all your suggestions,finally sorted the tank!!!!!!!!!!,used PERMABOND,FLEXON F246,a toughened acrylic adhesive.