Aprilia

Does anyone have any idea what they look like ? Or what to use instead ?

Hi guys,i am doing a light restoration on a Aprilia txr 312m my question is I want to use tubeless Michelin tyres, as the rims are tubed can I fit the Michelin tyres with tubes will it work? thanks derek.

i have a aprilia climber 240 have had it for about 5 months now and had no problems wth it till now. The bike was running fine then it just cut out took plug out to see if it was sparking and no spark so i changed the plug and it worked for about a hour and then the same no spark with new plug so i got another plug and that is sparking. any one know what could be causeing this to happen also dose anyone know what spark plug should be in a climber 240......................... thanks simon

My contact in Spain has located a nearly new Aprilia climber with only 300kms on it, any intrest to anyone pm me. Not silly money but guess not much demand?

Hi. Is the disc valve timing on a climber the same as a swm. Thanks

I converted my engine into 280cc and kept the same carburetor settings, the bike has plenty of torque but top speed is slower, do the jets on the 280s are different? anybody know the sizes of them? Thankyou

Ok, continuing from my previous post. Thanks to a top man on this very here TC, I've got myself a left side crankcase (Cheers Ross). My question is about setting the disc valve timing. Where does the valve sit in relation to TDC and which way round does it sit? Never been into a disc valve motor before. Cheers Graeme

Does anyone out there know what jetting there running in the Dellorto carb. I've got a 85 main and bike seems to load up and run rich over half throttle. Have gone thru carb, and have points and timing set correctly. Bike starts first kick runs great on bottom but loads up when you need to ring it out on a uphill section. Plug is dark. Just don't want to burn up the motor.

Ive got the chance of aTX311M but don't know a lot about them. I was after a air cooled mono for our clubs pre 90 route and was after a Fantic but the Aprilia has been offered me. Can I get parts for the Rotax motor ok and are there any known problems with them as this bike has a issue with the kickstarter. Thanks

hi just bought 280 climber as first trial bike were can i get spares for it as i need new air filter is there a manual available and one last question how do you check gear box oil

Hi I have an Aprilia Climber which i use to have some fun on at weekends, and just lately it has started overheating, i have checked the fan by shorting down to earth and it works fine, so i need to replace the temp sender. Can anybody help me with a outlet that can supply me with one of these? regards Russ

Just got myself a twinshock aprillia with a a hiro motor think it may be a tx 320??? looks to be in prety good nick but needs a kickstart shaft as its been welded has anyone got any info on theese bikes ? Only got it for the wheels and forks but its way to good to break and it sort of feels right steering angle ect, just needs the pegs lowering and moving back so i feel another project coming on Any info on parts availability or pics would be very welcome thanks in advance for your help . Will try and get some pics posted

A guy at our club asked me about testing the cooling fan on his 92 Aprila. I haven't seen the bike but he says there are three wires going into the fan and a single wire thermal switch. What is the best means to check if his fan is working? Can you direct me to a electrical schematic or tell me which wires to jumper across? Thanks for the help.

I could use some help i have had my bike standing for a couple of months and the clutch has stopped working , i have stripped it down as far as i dare and all seems in order , put it all back and still no joy. the problem is i can pull the clutch lever in and it wont work( ie the engine is still driving the wheel ) ,the springs on the plate must be working because the lever springs right back . is it something simple i am missing ?

Any source for Aprilia TXR312 rear sprocket? Does anyone know if the later model Aprilia Climber rear sprockets are the same as the TXR. Trials Shop here in the US is still on back order. All I need to get my TXR going.

looking all over but can't find a rear fender for my 89 aprilia sorry if this has been cover just haven't come across one found lots of other parts thanks

im thinking of getting an aprilia climber for nostalger purposes any thorts are they any good ? anything to watch out for i used to ride trials in the 90s and fancy collecting the classic 90s model bikes

hi i have just brought my first trials bike its an aprilia climber 240 1992 and i have had a rebuild done and put the engine back in but now i have the problem of I need a rear brake nipple and either a seal for the front brake calipor for in between the the 2 halfs or a new calipor so if anyone can help me with this could u email me about selling them or swaping them because I have 80% of a spare engine here. also could anyone tell me what they go like. how powerful is it a good first trails bike my email is rickyh1@hotmail.co.uk im in the uk thanks ricky

Hey good people of the forum. '93 Climber: stripped out the forks tonight as part of a full rebuild, the left side stanction chrome is very very badly worn. Does anyone know of a reasonably priced company that can re chrome it or will it be cheaper to buy another set of forks....if I can find any? cheers Graeme

Just got Aprilia tx 320 in boxes. There is two engines worth would i be better to source complete engine because it would need every bearing replaced and no saying what else.