Jump to content

reggie

Members
 View Profile  See their activity

  • Posts

    342

  • Joined

  • Last visited

 Content Type 

Everything posted by reggie
 
 
  1. reggie
    the carb needle has a delrin spacer under the needle clip, if this spacer is on the other side of the clip it will be very lean.It would probably run good just off of idle then really stumble and if you did manage to hang on long enough it would come on very strong.Good luck.
  2. reggie

    Tube Size?

    reggie replied to monty_jon's topic in Twinshock

    Michelin used to recommend a 17CD tube, now they use a 400 18 trial tube. Do not use a 3.50/4.00 x 18 tube use a larger 4.00/5.10 x 18 tube the chamber for the tube in a trials tire is huge if compared to a 4.00 x 18 knobby
  3. reggie
    Take a zip-tye and tie the centre of the kickstand spring to the kickstand this should give you a tiny bit of clearance.
  4. reggie
    Nothing wrong with the paper filters.The Beta does have the availability of the long range kit.The Montesa main clutch has to come off for oil changes to the best of my knowledge.
  5. reggie
    Try Wane's help on the Sherco website. The Beta forks are very similar.
  6. reggie
    Sometimes on the SWM rear exhaust box baffles can come loose. It is noisy but check without the final exhaust on the bike.
  7. reggie

    Beta 4T Carb Needle

    reggie posted a topic in Beta

    I would like to thank Billy Traynor for helping sort out the carb troubles that I had been having on my 2008 Rev 4t race. It would appear that most of my problems could be traced to the nylon spacer that is on the needle not being below the needle clip but above the needle clip.The midrange was terrible.Billy also suggested a slightly larger pilot and main jets.It looks like the bike is very close now, only some fine tuning needed.Thank you again for your help Billy.
  8. reggie
    Peter I am wondering on the off chance that you may have recently changed oil brands or viscosity.Good luck chasing down this noise.
  9. reggie

    Welding On Bike

    reggie replied to jeeves88's topic in Sherco

    Bond all wires together after diconnecting them.Better yet take ignition and all electrics off of the bike.
  10. reggie

    Welding On Bike

    reggie replied to jeeves88's topic in Sherco

    Bond all wires together after diconnecting them.Better yet take ignition and all electrics off of the bike.
  11. reggie
    I think you will need a main jet and a pilot jet.
  12. reggie
    Beta p/n 007360718 EBC FA495X GOLDFREN 282 GALFER 428 These are the cross reference numbers that I am aware of. reggie
 
×
  • Create New...