robido
Site Supporter
-
Joined
-
Last visited
Everything posted by robido
-
Had same problem. Get some stans notubes from a mountain bike shop take the valve core out use a syringe to squirt in about a cupfull. Put valve back blow it up and ride around for a while sorted mine
-
Gas gas one goes between sump guard and frame if that helps
-
Nice looking bikes. Have you got hfs setup in the forks if so how do you like them and which one. Cheers
-
Try in motion. Bultaco uk
-
Just stripped my front wheel down to respoke with stainless and measured my offset at 12.5mm from brake side so it could be 15mm is correct . Mines a 199a. Hope this helps
-
Where did it all go wrong. What happens to proper trials
-
Splat shop have kits for 1999 to 2013. Give Chris a ring
-
Plates will be ok they can run dry as do Pete's clutch. You won't regret buying one. Fit and forget I don't bother using a gasket as no oil to leak.
-
Pete Kirby 07886 745942. Nice chap very helpful. Not cheap but quality never is. I've had 3 from him work nice. Think they were about £450.
-
Get A Pete Kirby belt drive clutch no oil work brilliant. You won't regret it
-
Ebay. Or you can buy direct from Rupert ratio site
-
Terry weedy does a nice one. Look at his web site
-
That sounds like a bargain at that price. Room for some upgrades like Whitton alloy hubs and still be a cheap bike
-
-
Wrong engine for comerfords cub it should be points on side not dizzy engine
-
I use rustoleum bbq paint. Stays on and looks good. Got it on Amazon
-
The ag bikes alloy swing arm is a copy of a works bike. Ag has the actual bike in his collection. Ag bikes are located in north yorkshire uk
-
Yes you should be able to tell. There will be a close fitting washer on the crank which if you remove it you will see the rollers cage behind it. The washer is a precision fit inside the bearing outer as it keeps the oil in. Hope this helps
-
Sounds like a blockage and not circulating
-
I have 2 engines with the Pete Kirby belt drive clutch. Money well spent. Nice and progressive no slip no oil to leak don't need a gasket. Fit and forget. I also have a alloy one from Burton's its better than a standard one and a lot lighter but nowhere near as good as the Kirby clutch.
-
AG bikes in the UK do an alloy one
-
62 here and bouncing not to bad. Made a return after about 30 years things have changed a lot
-
Don't know who built that but Jim pickering does the Drayton c15 frame Really nice and well made at a good price
-
Try bob at upb
-
Honda mtx 125/200 looks the same
