cascao

Same Honda shadow fork seals....

Look for best aftersales support!!

Probably, 52mm is the lower leg hole diameter and 52,2mm is the seal outer diameter. this 0,2mm is for interference fit.

If torx T100 isn't available, be careful with improvisation a new tool since it can damage the finish. Protect it with a rag between tool and part. Probably a big nut will be able to turn this cap. Below the one I've made to formula brakes.

...I'm using fork boots (gaiters). They keep all mud and dust out of seals and give some protection from rocks. https://www.instagram.com/p/BjCt3t2Boo5/?taken-by=leocm74

Probably bend shaft. Take a look in this video

Something new is on the way http://www.mecatecno.biz/

Sherco hold 450cc as manual says. Gasgas sould be close

Last weekend I worked in my practice area moving a rock with a farm jack. https://www.instagram.com/p/Bizisx9B8hy/?taken-by=leocm74

Take a look at this manual from formula Garfo formula regulagens.pdf

See attached file from formula Garfo formula regulagens.pdf

Malcolm, you need to open the top cap and turn forks upside down. On coil side this will drain most of the oil. On dampening side half of the oil will be inside cartridge and it need be disasembled to drain oil.

Hope sherco improve their aftersales soon....this is a shame for them.

The impeller of my motorcycle had better days...and shipping from france to brasil take too much time. So making one was the obvious choice.

Tech forks share same seals as honda vt600 shadow!

Found that doing this way (not completly disasembling) old oil will be trapped on hydraulic cartridge. On coil side this can work.

There english subtitles in this video.

Honda specify ATF oil for forks on some bikes like XR's.

Have it from Leonelli... 026.D30 leonelli.pdf 016.D30 Leonelli.pdf

Have Tech forks on a 2015 motorcycle. I completely disassembled the forks and changed oil 11 months ago. Do I need disasembly and clean it again or just opening the cap and draining old oil and putting new is ok? Which oil you prefer? 5w or 7,5w?

Multimeter at AC volts, ok?

If there a fail in right side engine will burn oil from gearbox and smoke badly. If there leakage from generator side will should de able to see some leakage under electic coils. But this usually happen on much older bikes.... Seems like your carb have some blockage. Return the settings for what they are before problem started and give a good clean with compressed air. Install a gas filter since due the position of gas cap in this rear tank models, it is easy to get dirt inside gas tank.

You can close a bit the reed valve stoppers to tame any engine....

Formula brakes calliper tool

Made mine from a nylon rod turned on lathe. The magnet was pressed after