monty_jon

This link will take you to the results page: (click on the pdf file) Bewdley

top of the page, tab next to Forums or just type in: www.trialscentral.com

On the trials central home page, in UK news

Somehow I dont think Im the cock, Ive never put red diesel in my bike!... Whats he put in the gearbox, building sand?

Its been on ebay since about January, maybe it

Why would there be red diesel in his tank

Sounds like the fuel tap is blocked, might be worth taking it apart for a good clean?

The R should be fine, makes no difference (B,E & 5 are the important parts)

You hardly notice its there, its only like having a couple of bags of sand in the boot

Did the 123 have odd size wheels?

Not tried one on a focus, I had no problems on my old escort diesel They are a lot better than using trailers!

I agree, can't be any worse than the hebo ones!

They did a couple of Greeves MX cranks for me a few years ago, they are very helpful and knowledgeable

I had the same problem with a BSA years ago, it turned out the yokes where incorrectly machined

Hi Sounds like a very rude company, I sell quite a bit of stuff on ebay that goes to Australia without the slightest problem (so they can't blame ebay) Most UK traders are happy, genuine people

If you are unsure of the material used cut it out and start again

I

It would be nice to know who it is? I’m guessing its Sepp Blatter

I use a small HVLP spray gun its very good for bike parts, you can get the cellulose paint off ebay or a local paint supplier Use anti-bloom thinners & jet-black paint for the frame. Make sure you prep well with wet & dry and a good coat of primer first Use a spray gun like this, better than cans and lasts years! gun

Be aware that 2k paint is very dangerous, it contains isocyanide I get some decent results with cellulose paints

Hi simonwatkins What springs did you use, as I

Sounds like its faded, probably nothing you can do other than buy a new one

Worth a try, as stated above wheel bearings don't last long anyway

Its not just a case of measuring and copying, sherco probably invested a lot of money and time in choosing the correct manufacturing processes and material choices for each component It

My mate has asked me about this bike on pistonheads (hes after a cheap bike to start on), I rekon its a bit too cheap? But Im no expert on trials bikes! Sherco