stpauls

Remember that people have been killed when over-inflating tires to really high pressures, causing them to explode with extreme force.

Shocking!

No special tools needed. It's easy. Our cat could do it!

I think the Greeves Challenger was a Scrambler, not a Trials bike. It might be a bit too lively for Trials, even with lower gearing. However, I regularly see two pretty original looking Greeves Anglians with leading link front forks, Villiers engines and the cast aluminium front down tube being ridden in Classic Trials, on the Middle route by experienced riders in the south West of England. They are as good as me, if not better!

Has anyone removed the starter motor from a Sherco TY 125 and replaced it with a cover or blanking plate? Information appreciated.

What year is your Beta Evo 200? I have spoken to several VERY experienced riders in the south of England, Expert, former Expert and Clubman riders. These have been riding 2019 models and new models purchased in 2021. They have ALL complained of the same characteristics, which are that the engine spins up too quickly. A side by side comparison with the flywheels from a Beta 250 and a Beta 200 shows that the flywheel mass on the 200 is substantially less. Additionally, there is no tapping for an S3 flywheel weight to be fitted. Bikes have been cured by fitting a flywheel from a 250 and an extra base gasket. Possibly other mods too. Never mind the comments about screwing up from the galah, my question remains; why did Beta ruin the Beta Evo 200 and do the latest 2022 models still have the lightened flywheel and raised compression?

Hello The Beta Evo 200 was much appreciated by older riders, who wanted a softer, less aggressive power delivery. Can anyone enlighten me as to when Beta ruined the Beta Evo 200cc by lightening the flywheel, raising the compression ratio and other "improvements" which have spoilt the soft, mild, tractable nature of the engine, making grip elusive in difficult conditions, even for experienced riders? The 2020 models still had the above "improvements". Do the 2021 and/or 2022 models also suffer? Thanks

The B40 is far too heavy. A Bantam is much lighter and easier to handle. Why not buy a Bantam trials bike that just needs tidying up? Even better advice would be to buy a modern 125cc trials bike and learn to ride that, rather than ruining an old British bike.

In my 2014 Sherco ST, after experimenting with several different oils, I used 450mm of ATF Dextron 3.

Looks nice. Russian engine - Minsk? And a British made frame. Only ever seen one at a trial - Somerton Classics a few years ago.

Hi Anyone know how much fork oil in each leg for a Honda MT125 Elsinore 1974-1976? Thanks

If you search the web, or e.bay, someone sells 100 link cam chains. The one I bought was branded "Tour Max". However, I cannot remember where mine came from. Here's one here. 25H 100 Link Cam Chain For Honda XR200R XR200 XR185 XL200R XL125 XL100 TL125 | eBay

You mean gearbox oil (which is shared by the clutch as well). I use 450ml of ATF in my 2016 250 Sherco.

You have 6 clutch springs. Take 2 of them out. It will be 33% easier to pull in.

Quite so. If a job's worth doing, it's worth bodging. You could even try chewing gum or what about wallpaper paste. Or, you could do it properly.

Have a look around here: Home - Beamish Owners Club

How high are your current bars? You can get new bars with up to a 6.5" rise.

Check the timing mark. I am wondering if the timing has been retarded to soften the power at higher revs - perhaps by too much. About 3mm retarded (not degrees) will soften the power. A bit more and it will run badly. You will need to remove the flywheel to check this. Special tool needed (E.bay, a few quid).

Cheap Chinese text editors are rubbish too!

You have a rear tanker, which has a small fuel pump, which is reliable. You will most likely have a tiny split/hole in the long fuel hose which is about 500/600mm long and runs up under the rear mudguard, in a loop. Use ATF fluid in your gearbox and it will cure any clutch drag. .

Wait until your other half goes shopping then bung it in the washing machine.

A 250, with a flywheel weight, and with a low compression head and the timing retarded 3mm. Never ridden a Beta 200. There's one on E.bay at the moment. Been relisted. 3 years old. £3850 - been up to that last time! However a brand new one is only £5500. I suspect the seller is running it up to try to get someone to bite nearer £4000.

Only if you don't oil it every time you wash it.

Electric trials bikes? You see hardly any at trials competitions. There must be a reason. Best learn on an ordinary, modern two stroke trials bike, before venturing into the electric world.

Get yourself a girlfriend.