| |
-
After riding the TRS for a year, I did something I swore I would never do. Having ridden the Expert line since 1974 I figured it was time to ride an easy line I have
3 generations of my family riding and soon will have 4. I hope to still be competing well into my 80's.
So I bought a 301 Montesa 75th anniversary edition.And dropped down a class. It is heavy, but I am having a blast!
-
You do have the center nut to remove. I just use a rattle gun.
-
Pull the mag cover off and turn the flywheel backwards with a socket and ratchet. If it`s mains it will probably free up. Happened to me during an event and pushed it back to the pits, spun it loose made it back to section 3 and it stuck again. Pushed it almost 5 miles that day!
Of course you have to do new mains, seals and gaskets.
-
Yes , I found a solution. I have only stalled once in 15 months now.
-
You have to weigh the whole bike.
-
So did you buy shocks. I bought another TL250 last weekend. Was supposed to had the front end pulled in, but not. Interestling it had a rear shock mod done. Stockers were 14 inch long, this has 13.5 inch shocks. Thinking of a set of 15 inch shocks.
-
It's worn out, take it to a Sherco dealer.
-
Remember you have to loosen the rear engine mount bolts to get the shaft out.
-
I show 22201-376-000 are the correct plates.
-
The chrome tubes should be straight forward replacements as the guts have all the parts on them. I have no idea on quantity the Zokes on a Ossa use. The rest of it should be similar to a Gasser with the same type. Should be a video out there somewhere. Not hard if you have an air gun, otherwise try loosening the lower bolt in the fork with it compressed before you take anything apart. Minimum is all you need is new fork seals and dust seals.
-
I once put a Beta under the Christmas tree and swore to her I had nothing to do with it. It was all Santa`s fault. That was in 1989. Then last year I took her to the Yamaha shop to put a deposit on her new Waverunner, we immediately stopped and I put a deposit on my 75th Anniversary Edition Montesa 301. Fair is fair.
-
Sounds more than an idle. What oil ratio are you mixing in that old Bike. My first trials bike was a 1970 247 also, but that was 50 years ago!
-
The sections now are set quite bit tighter than in 1970. You will find slower is better, especially as when the bike was made you never used the clutch in a section.
-
White should be a head gasket leak.
-
I would bet your crankcase seal is bad on the clutch side. The heavier oil just made it obvious.
Or you have a head gasket leak. White smoke or black/blue?
-
You would like the EVO 250 better. And the Beta does start easier than your Montesa.
-
Have you cleaned the exhaust lately?
-
Yes, it is normal on a trials bike to remove your foot off the peg to shift.
-
Just the right side case and clutch to get at the shift shaft.
-
Probably broke the rivot to the shift shaft. Can also just be the spring.
-
That is so funny after I posted it in 2018!
-
The transmission shafts are not set properly in the case, so not flush.
-
There are tons of tlrs just dying somewhere. The xr's would make them choppers, unless you just ride street.
-
Using the middle finger is like being left handed. Right handed is right, but the middle finger is not wrong!
-
Dabill and Peace went clean. Dougie is 5th on 2.
|
|
