Trials Training And Technique

So today I went out on the bike for the first real time. And tbh it scared me senseless ... I was just doing figure 8s and I was fine riding circles, could balance no probse but I then used 2nd gear and a few more revs to move off .. front lurched up and I felt totally out of control after nearly coming off the back. Properly had the shakes after and couldn't get back on it. Now I'm worried I've made a mistake trying it .. can anyone help / share their advice or experience? Did you all start the same ? Steve

Sometimes I can get over this obstacle without smacking the foot peg mounts and kick stand bracket but mostly they hit. There is no rear wheel lift. What am I doing wrong? (I think it is everything but everything is hard to work on.) The one time you don't hear the hit, the front tire deforms a little so impact does help. How do you safely impact a sharp obstacle like that. Do you need to come down on it rather than hit the face or....?

Hello, I was recently cruising thru the training forum and I notice there is no advice for training with the engine switched off. When I first purchased my new montesa it was the first of February and I was weather locked in the garage with single digit temps and two feet of snow in the yard. So I first focused on static balancing in a stationary position finding the correct vector for the front wheel so I could learn how to balance the motorcycle with my feet on the pegs not going anywhere. At first it was very difficult and I was only able to get 10 to 15 seconds on the pegs before putting my foot down, as the weeks went by with continued practice in the garage my…

I need some help with my d.bleep technique, Any suggestions? https://youtu.be/heMAclV1Tnk

I've just purchased a very decent condition Gas Gas Contact JTR160 trials bike to try and learn the sport on. I've made some feeble attempts to learn with my Honda TRL200 but find the 4-stroke with the engine braking throws me off. I do not have that issue now with this 2 stroke. I've been a checker at a local event for the last five years so I understand the concept of trials. Watched tons of YouTube videos, too. My question is, how to begin from scratch? If you were just starting out, all over again, what would be your plan of attack and how would begin to practice? Thanks.

I've been trying to learn to front wheel hop. I can do reasonable beginner hops on my bicycle, but the moto eludes me. A timing thing and also the bigger leg movements needed I think. So I was thinking how I could help the process along. I knocked up a very rough and ready jig to hold the bike up so I could hop without continually having to stop after every attempt. It has a few problems being so rough, but it works. In just two short sessions my hops have improved more than they have in the past few weeks (still absolute garbage, the video certainly isn't a how-to!) https://www.youtube.com/watch?v=-PCeKD7R8Qs

Hi, I've been riding a road bike for the last couple of years, first a 250cc and currently a 700cc. I have never ridden off-road and would like to have a go at trials. I'm considering selling my road bike and getting a trials bike but would like to have a go first to see if I will enjoy it and actually have any aptitude for it! I am currently looking at an experience day with Trials Day in Leek, Staffordshire but wondered if there is anything closer to home (I live in Hampshire). I've come across Trick in the Sticks in Kent but it's a full £100 more than Trials Day for a full day including bike hire. EDIT: Have just trawled through the last 6 years worth of…

Something has been nagging at me and I wanted to get input from you guys. So when we're on trail rides, we always try to look as far ahead as possible. This also counts for techniques like pivot turns, floater turns, etc.. The question is, if you have multiple obstacles in quick succession, especially requiring intermediate techniques like the double blip so you can't simply roll over everything, when do you switch your focus from the first obstacle to the second? For instance, let's say you got a double ledge with the first being undercut and requiring a japzap. To get a solid front wheel punch, you need to look at the ideal point of impact righ…

Got a 2006 250 rev 3 with low use having trouble with an erratic running when warmed up pulls through gears fine but looses response just off tick over goes droggy n plenty pinking Almost like it's too rich but with pinking at same time to date I've changed Crank bearings and seals rings case gasket cylinder gasket new plugs of differnt heat range stator and cdi brand new and good used coil Inc lead n cap kill switch disconnected 2 carbs Reed block assembly flywheel new air filter tank drained tap cleaned out can't pick up on any air leaks spraying carb cleaner around it problem was there before rebuild n suspected Crank seal I am thinking it needs a crankcase pressure …

Hi all I am really struggling to progress the biggest problem I have is just having nowhere to practice and No one to practice with When I am at a trial I find some sections very easy and clean all the time and some reall hard like lucky to get a 3 but then I cant practice so every trial is the same and No progress is being made I find it very hard to ride in the rocky burns and over any sort of obstacle I just cant get any rear wheel lift to get over and just clatter into then I need to practice getting back wheel up I watch videos on YouTube all the time I know what I should be doing but just nowhere to practice it any thoughts on what I could do

Good evening fellow riders, I am getting arthritic type pain in my index fingers and knuckles after riding. I am also getting pointy bits on the side of my index knuckle joints from the obvious repetitive use of the clutch and brake. Has anyone else experienced this, and have any wonder cures or suggestions, I have tried riding with two fingers on the levers, but find that quite awkward. Cheers in advance.

Hi does anyone know of any trials training centres near to bath /bristol. I would like some lessons to get me off on the right foot many thanks j

These are a bit on the short side but always happy to see more training clips out there. Kind of fun to see the Spanish version as well...

Hi all, Hoping you can help with a bit of technique,I’ve been practicing the jap zap over some barrels and these tyres. I can’t seem to get the lift I need which is stopping my momentum to get over. its a 300cc and I’ve been trying in second and third gear. any help would be appreciated,thanks

Is it just me (rubbish older novice) or is grip reduced by cold weather on a trials bike? I was out yesterday and on admittedly, very soft ground I could barely move forwards, never mind anything resembling a tight turn without the front washing out, even on level ground. 4 psi front and 3.5 psi rear. Michelins.. The bike is a 2016 250 Beta Evo 2T so I can't blame the bike at all. I'm finding it very frustrating, any confidence I had is literally slipping away. Also, long steep slippery descents, what gear do you guys use? I'm using first going down, clutch engaged and as much front and rear brake as I feel comfortable with... Feel like I'm banging my head…

Hi I'm new here and new to trial. Have some enduro and street bikes background. Beta 250evo is my bike. Would like to ask how should look beginner training session? What exercises and how long or repetition during session should do to maximaze my learning curve? Thanks for all inputs

Feel free to leave a constructive comment!! If you have mastered the technique, tips are welcome

I didn't get flamed for posting the enduro bike video for my last how to here. I'm doing this on the dirt bike because of its universal appeal, lots of folks crosstraining. Pretty much works the same on the trials bike. I always see folks confused over the japzap vs double blip so I put a back to back slow mo comparison of my interpretation of the maneuvers in the video. Hope it helps someone.